Aastra Telecom 55I, 57I CT manual XML Softkey LED Control Feature, LED Behavior XML Attribute

			SIP IP Phone Models 53i, 55i, 57i, 57i CT Release Notes
				Enhancements/Changes in 2.0.2, Build 1040
Issue Number	Description of Feature/Enhancement
ENH06058	XML Softkey LED Control Feature
	A feature has been added to the IP phones that allows an Administrator to control
	the behavior of XML softkey LEDs. You use the AastraIPPhoneExecute object to
	implement this feature.
	Note: This LED feature is applicable to XML softkeys only (softkeys (top or bottom),
	programmable keys, and expansion module softkeys). The softkey must be
	configured for XML before you enable this feature.
	The following table describes the behaviors you can assign to XML softkeys and the
	attribute you enter in the AastraIPPhoneExecute script.
		LED Behavior		XML Attribute
		on		URI = “Led: <softkey type>= on”/
		off		URI = “Led: <softkey type>=off”/
		fastFlash		URI = “Led: <softkey type>=fastflash”/
		slowFlash		URI = “Led: <softkey type>=slowflash”/

The command for LED control is sent using the XML http post from one of the XML push server lists. The following example shows an XML LED command in an AastraIPPhoneExecute script.

<AastraIPPhoneExecute>

<ExecuteItem URI=”Led: topsoftkey20=on”/>

<ExecuteItem URI=”Led: softkey1=off”/>

<ExecuteItem URI=”Led: prgkey2=fastflash”/>

<ExecuteItem URI=”Led: expmod2 key20=slowflash”/> </AastraIPPhoneExecute>

Notes:

1.Using the Aastra Web UI, you must set the XML push server list from where the XML http post is being sent.

2.The LED states specified in the AastraIPPhoneExecute script are not saved after a reboot.

RN-001029-00, Release 2.0.2, Rev 02 21