Owner’s Manual - VoiceCom 2000
12 Troubleshooting
Problem | Cause | Remedy | |
|
|
| |
|
|
| |
VoiceCom 2000 does | There is no supply | If necessary, replace | |
the fuse and check the | |||
not switch on. | voltage. | ||
cable and connections. | |||
|
| ||
| The ignition is not | Turn on the ignition. | |
| turned on. | ||
|
| ||
|
|
| |
| The ignition line is | Check cable and 1A | |
| interrupted. | fuse. | |
|
|
| |
The person you are | The microphone is | Connect the | |
calling cannot hear | not inserted or the | microphone plug to the | |
you. | microphone cable is | electronics box. If the | |
| damaged. | cable is defective, it | |
|
| must be replaced. | |
|
|
| |
The person you are | The microphone is in | Mount the microphone | |
calling complains | an air stream. | somewhere else or | |
about interference |
| perhaps reduce | |
noise. |
| ventilation. | |
| The phone is very | Increase the distance | |
| close to the VoiceCom | between your phone | |
| 2000 parts or the car | and the VoiceCom | |
| radio. | 2000 or radio. | |
|
|
| |
The person you are | The microphone and | Increase the distance | |
calling complains | the speaker are not | between them or | |
about echoes | far enough apart. | reduce the volume. | |
|
|
| |
| The volume is too | Reduce the volume or | |
| loud or the | perhaps reduce the | |
| microphone | microphone sensitivity | |
| sensitivity is too high. | at the electronics box. | |
|
|
|
- 24 -