AT&T CL81101, CL81211 quick start Battery installation and charging, Charge light Step

Page 4

Battery installation and charging

Once you have installed the battery, the screen indicates the battery status. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 10 hours of continuous charging.

NOTE: If you are on a phone call in low battery mode, you hear four short beeps every minute.

BY 1021

BT183342/BT283342

Step 1

Plug the battery connector securely into the socket inside the handset battery compartment, matching the color-coded label. Insert the supplied battery with the label THIS SIDE UP facing up as indicated.

Step 2

Align the cover flat against the battery compartment, then slide it upwards until it clicks into place.

CHARGE light

Step 3

 

Charge the handset by placing it face forward in the

 

telephone base or charger. The CHARGE light on the

 

top of the handset is on during charging.

After you install your telephone or power returns following a power outage, the handset will prompt you to set the date and time. To skip setting the date and time, press OFF/CANCEL.

IMPORTANT INFORMATION

1.Use only the supplied rechargeable battery or replacement battery (model BT166342). To order, visit our website at www.telephones.att.com or call

1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.

2.If you do not use the handset for a long time, disconnect and remove the battery to prevent possible leakage.

Image 4
Contents CL81101/CL81201/CL81211 CL81301 Installation Avoid placing the telephone base too close toTelephone base installation Telephone base and charger installationCharger installation Step Battery installation and chargingCharge light Step QCID/VOLUME Quick reference guide handsetUsing menus Main menu Quick reference guide telephone baseSet date/time To set the date and time manually Telephone settingsPress MENU/SELECT Telephone operation Making a callAnswering a call Press PHONE/FLASH or /SPEAKER Ending a call