AT&T CL84200 Show Out of range or No pwr at base on, To register a handset to your telephone base

Adding the handset to your telephone base

Adding and registering handsets

The handset needs to register with the telephone base before use. You must register each handset separately.

When first purchased, all expansion handsets
show Out of range OR No pwr at base on the	Out of range OR
screen. The new handset should be charged	No pwr at base
without interruption for at least 30 minutes before
registering to the telephone base.
To register a handset to your telephone base
1. Make sure the handset is out of the telephone	1.Press HS LOC
base or charger and alternately shows 1.Press
HS LOC on base 4sec and 2.Then press # on	on base 4sec
handset before you begin registration.

2.Press and hold /HANDSET LOCATOR on the

telephone base for about four seconds (until the	2.Then press #
red IN USE light on the telephone base is on)	on handset
and then release the button.
3. Press # on the handset. The screen shows
Registering... Please wait. It takes up to 60
seconds to complete the registration. Then
HANDSET X Registered appears on the screen,
with X being the handset number (1-12) and the	Registering...
handset beeps. The handset is now registered		Please wait
with the telephone base.

4.If the registration is not successful, the handset screen displays Registration failed appears on the

screen. Please start again from steps 1-3 above.	HANDSET X
	Registered

NOTE: You cannot register a handset if any other system handset is in use.