TELEPHONE OPERATION
continued
Special Telephone Services
If you subscribe to special local telephone company services like Call Waiting or Call Forwarding, you can access them by pressing 
whenever you would press the switchhook on a regular phone.
Redial
To redial the last number dialed from the handset:
1Press 
.
2Wait for the PHONE indicator to go on and for a dial tone.
3Press 
.
The last number you called is stored in the redial memory until you dial another number.
Mute
Mute allows you to hear your caller but prevents the caller from hearing you.
1Press 
.
2The MUTE/LOW BATT indicator will light to indicate the Mute feature is activated.
3To continue your conversation,
press 
again.
Ringer Mute
Press 
on the handset during incoming ringing to disable the ringer for the duration of the call.
Hold
The Hold feature allows you to keep a call on the line while you step away from the phone or while you or someone else takes the call on an extension phone.
1Press 
.
2The PHONE indicator will blink slowly to indicate the call is on hold.
3To release Hold, press 
again.
IMPORTANT: If you are using the Hold feature to switch to another extension, you must first place the call on Hold. After the extension phone has been picked up, release
the Hold feature and press 
on the 9110 to resume your conversation on the extension phone.
Advanced AutoSelect Feature
The Cordless Telephone 9110’s advanced AutoSelect feature will automatically select the clearest channel, even during a conversation. During automatic channel change your conversation may be interrupted for about 1 second while the unit scans and selects a new channel.
Temporary Tone
If you have dial pulse (rotary) service, this feature allows you to enter codes or tones needed to operate answering machines, or use electronic banking services, calling cards, and other special services. This feature will operate most special services; however, some services may actually require a touch tone line. To be sure, ask the company that provides the special service.
NOTE: If you have touch tone service, you do not need to use the Temporary Tone feature.
To use temporary tone dialing:
1Dial the call normally.
2Press 
.
3Enter numbers or symbols required.
4End the call normally (Temporary Tone is automatically shut off).
Programming the Ringer Type
The handset ringer is capable of four different types of ringing tones. The following sections detail how to change the different tones and to turn off the ringer on the handset.
To program, the handset must be
.
To select a different ringer type do the following:
1Press 
.
2Press 
.
3Press a key ( 
- 
) to select a ringer type.
4Press 
.
Turning Off the Ringer
To turn off the ringer on the handset, do the following:
1Press 
.
2Press 
.
3Press 
to turn off the ringer.
4Press 
.
To turn ringer on again, see “Programming the Ringer Type.”
Checking the Ringer
To check the ringer which is currently programmed, do the following:
1Press 
.
2Press 
.
3Press 
again to check the ringer.
4Press 
.
Page/Handset Locator
This feature is useful if you misplace the handset.
To locate the handset using the Handset Locator feature:
1Press 
.
2A repeating paging tone is sounded at the handset for approximately 30 seconds.
To cancel the Handset Locator feature:
Press 
on the handset or press 
on the base.
4