AT&T E2903B user manual Intercom, Handling incoming calls

HANDSET 1

12:45PM

INTERCOM TO:

INTERCOM

NOTE: At any time, a maximum of two hand- sets can be used on an intercom call, and another handset

can be used on an out- side call at the same time.

Telephone operation

Intercom

Use the intercom feature for conversations between handsets.

1.Press INT. The screen of the originating handset will show INTERCOM TO:.

2.Enter the handset number of the destination handset (1, 2 or 3). The display will show CALLING HANDSET X. The destination handset will ring, and its screen will show HANDSET X IS CALLING.

NOTES:

•Before the intercom call is answered, you can cancel the intercom call by pressing OFF/CLEAR or INT.

•If the destination handset is not answered within 100 seconds or if it is in the directory or call log mode, or out of range, the originating handset will show the message

NOT AVAILABLE.

3.On the ringing destination handset, press PHONE/FLASH, INT, SPEAKER, or any dial pad key (0-9, * or #) to answer the intercom call.

NOTE: On the ringing destination handset, pressing OFF/CLEAR or MUTE/DELETE will temporarily silence the intercom ringer.

To end the intercom call:

•Press OFF/CLEAR or INT on either handset.

-OR-

•Place either handset in the charger or telephone base.

Handling incoming calls

The telephone will beep if you receive an outside call during an intercom conversation. You can either:

•Press PHONE/FLASH to end the intercom call and answer the incoming call.

-OR-

•Press INT or OFF/CLEAR to disconnect the inter- com connection without answering the incoming call. The incoming call will continue to ring.

16