L E P H O N E M E M O R Y | AT&T HS-8500 specification

T E L E P H O N E M E M O R Y

The phone numbers you store in memory are saved when you change the handset battery, or in the event of a power failure. This cordless phone can store 20 telephone numbers that you can dial just by pressing mand a number button.

Storing Memory Numbers

1Make sure the PHONE light is off.

2Press and release G. The PHONE light blinks.

3Enter the number you want to store (up to 24 digits)

— OR —

Press Rto store the last number dialed.

4Press m.

5Enter a memory location (01–20). The handset sounds a tone to confirm the number has been stored.

NOTE: You can use the self-adhesive directory label to keep a record of telephone numbers stored in memory locations. It’s best to write on the label before applying it to the phone.

Changing/Replacing Stored

Memory Numbers

You can change or replace a stored number by storing a new number in its place.

Storing a Pause in a Memory Number

While storing a number in memory, hold down the button of the number that comes before the pause until you hear a second beep. This inserts a two-second pause after that digit. To insert a longer pause, hold the button down until you hear a third or fourth beep. Each time you hear a beep, the pause is two seconds longer.

For example, to store 9, PAUSE, 555–0123 in memory location 3: Press G, 9(hold until the second beep),

5550123, m, 03.

Dialing Memory Numbers

1Press P.

2Press m.

3Enter the memory location (01–20) of the number you’re calling.

Erasing Memory Numbers

1Make sure the PHONE light is off.

2Press and release G. The PHONE light blinks.

3Press m, then enter the memory location (01–20) you want to erase. The handset sounds a tone to confirm the number has been erased.