Samsung WEP180 quick start Before using your headset, Put your headset in pairing mode

Page 1

Quick Start Guide

Samsung

Bluetooth® Headset

WEP180

Get connected in 4 quick steps

Charge your headset

Put your headset in pairing mode

Turn on Bluetooth on your phone and pair with headset

Test and use

Start here

Before using your headset

Thank you for purchasing the Samsung Bluetooth Mono Headset WEP180, we hope you will be delighted with its operation.

Take a moment before you get started to familiarize yourself with your new headset.

Multi-Function

Adapter jack

button

 

Earpiece

 

Volume control

Indicator light

 

buttons

Microphone

CheckCheck thethe accessoriesaccessories

MakeMake suresure youyou havehave thethe followingfollowing itemsitems withwith youryour headset:headset:

TravelTravel adapter,adapter, User’sUser’s Guide,Guide, 11 earear hookhook

NOTE:

The items supplied with your headset and the accessories at your Samsung dealer may vary, depending on you country or service provider.

Bluetooth version: 2.0 (compatible with devices of

Bluetooth version 1.1 or higher)

Supported Bluetooth profiles:

-Headset profile

-Hands-free profile

ChargeCharge youryour headsetheadset

Charge the headset's battery fully before using the headset for the first time.

1Plug the travel adapter into the jack on the headset.

2Plug the travel adapter into the electrical outlet.

Charge the headset until the red light on the headset turns to blue.

The headset will be fully charged in approximately 2 hours 30 minutes.

3Remove the travel adapter from the headset.

NOTES:

The headset cannot be used while charging.

Use only a Samsung-approved charger or adapter.

Headquarters:

1301 East Lookout Drive Suite 150

Richardson, TX 75082

Internet Address:

http://www.samsungmobileusa.com/ accessories

Customer Care Center:

1-888-987-4357

Guide No.: GH68-12459A

09/2006. Rev. 1.0

Put your headset in pairing mode

Before you can use your headset, you must pair it with your phone.

1Ensure that the headset is off (see Turn

headset on/off on the reverse side of this guide).

2Press and hold the Multi-Function button until the indicator light turns on in blue (approximately 8 seconds).

Turn on Bluetooth on your phone and pair with headset

1Set your Bluetooth phone to discover the headset by following your phone's guide.

Typically, the steps involve going to the Settings, Connection, or Bluetooth menu on your phone and then selecting the option to discover Bluetooth devices.

Your phone will find the Samsung WEP180 headset. your headset will be displayed as Samsung WEP 180/185.

2Select your headset.

3When the phone asks if you want to pair with it, confirm by selecting Yes or OK.

4Enter the headset passkey or PIN, 0000.

Test and use

Your phone and headset are now paired and ready to make and receive calls. To confirm they are operating properly, make a call:

1Place the headset over your ear.

See Wearing the headset on the reverse side of this guide.

2On your phone, make a call to the number you want.

3If your phone and headset are successfully paired, you will hear ringing on the headset.

After you have successfully paired your phone and headset, you do not need to repeat these initial setup steps each time you use the headset.

Using your WEP180

See Features and Functions Guide on the reverse side of this guide

for information on using your WEP180.

Image 1
Contents Put your headset in pairing mode Before using your headsetTurn on Bluetooth on your phone and pair with headset Test and useTurn the headset on/off Use enhanced featuresWear the headset Use the ear hook