Operation with your GN 1000 RHL accessory

To connect your GN 1000 to the GN 6110, complete the following:

1.Connect the GN 1000’s connector cord to the yellow-marked hook switch [AUX] socket on the bottom of the base [A].

2.Consult the GN 1000 user guide to complete the set up.

Note: If you cannot locate the GN 1000 product box and/or user guide,

consult GN Netcom’s web pages at www.gnnetcom.dk.

Your GN 6110 is now ready to use with your GN 1000, and you may proceed to Section 4.4.

4.4 Operation with your GN 1000 RHL (accessory)

Turning headset ON:

Open the headset boom arm. The headset indicator lights for 2 seconds, and then continue to ﬂash slowly as long as the headset is on.

Turning headset OFF:

Close the headset boom arm. The headset indicator lights for 2 seconds, after which it will turn off.

Making calls:

1.With the boom arm open, press the Multifunction Button on either the headset [C] or the base [B]. An audible tone will be heard and the connection will be established shortly.

2.The hook switch will be activated, and your telephone’s handset will be lifted.

3.Dial the desired number when the dial tone is heard.

The headset indicator and the base’s on-line indicator will ﬂash rapidly for the duration of the call.

Answering calls:

1. Press the Multifunction Button on either the

	headset [C] or the base [B], or open the headset
	boom arm [A] if not already opened. If the head-
	set is already being worn, an audible beep will	C
	indicate an incoming call, after which press the A	C
	indicate an incoming call, after which press the A	B
	Multifunction Button.

2.An audible tone will be heard, and you are now connected to your caller.

The headset indicator and the pairing indicator will ﬂash rapidly for the duration of the call.

Ending calls:

1.Press the Multifunction Button on either the base or the headset, or close the headset boom arm. Your call is now terminated.

GN6110_contents_EU_07-11-03.indd 11

20-11-2003, 14:39:27