Cooper Lighting ADY071447 installation instructions Large, Outdoor, Visor and Non-Visor

Installation Instructions

Sheet 1 of 2

Vault

C-ScrollRoundel

Large, OUTDOOR

YR (16.5")

(Yoke mount, Remote ballast)

Visor and Non-Visor

Warning: Before starting any work ensure that all sources of power are turned off. All work must meet local/national codes and be performed by a certified electrician. Do not

These installation instructions are valid with the above Ametrix styles.

mount fixtures vertically.

Exploded view and part call-out

#6-32 x 1/2		Outdoor J-box
		(by others)
Socket cap screw	1/2" Compression
(x2)	fitting
Yoke
		Yoke end cap

#10-32 x1 End screw

#6-32 x 5/8	#6-32 x 1/4
	Screw (x2)
Socket cap screw

(x3)		1/4" Fasteners
	Fixture head	(by others)

1Mounting yoke to outdoor surface

Yoke end cap

#6-32 x 1/4 screw(x2)

Yoke end cap

#10-32 x 5/8

End screw (x2)

1/4 Fasteners (by others) (x4)

1.To secure yoke to outdoor surface, the fixture head must be removed. First, remove both #10-32 x 5/8 end screws.

2.Remove one #6-32 x 1/4 screw to remove yoke end cap and fixture head. Place both fixture head and yoke end cap in a safe place.

3.With fixture head and yoke end cap safely stored, secure yoke to outdoor surface using four(4) appropriate 1/4" fasteners (by others).

2Wiring and sealing outdoor fixture

#6-32 x 1/2 Socket cap screw (x2)

1/2" Compression fitting

#6-32 x 5/8 Socket cap screw (x3)

1.To seal fixture head, after installing lamp, all screws and latches must be secured on door face. Holes above latches receive the #6-32 x 1/2 socket cap screws. The center hole(s) receive the longer #6-32 x 5/8 socket cap screw.

2.Slide 1/2" compression fitting down fixture head wire and splice wit power feed, ensuring all connections are properly matched. Seal 1/2" compression fitting to outdoor surface and ensure a watertight seal.

3Aiming the fixture

#10-32 x 5/8 end screws

Fixture head indicator

40

Yoke arm indicator

1.To aim fixture, loosen both #10-32 x.625 end screws. When the PointGrabTM system indicators are lined up, the slope of the lens face is 40-degrees. Each subsequent notch is an additional 10-degrees.

2.When the fixture head is adjusted to the desired angle, re- tighten end screws to secure the position.

ADY071447 Rev A (ECN070295)