To initiate pairing:
1.Place the BLUETREK® X2 and your mobile phone within 0.3 meter (1 foot) from each other.
2.Switch on your phone and select its Bluetooth® discover mode (refer to the Bluetooth® mobile phone user manual).
3.When the BLUETREK® X2 is switched off, press and hold the TALK button for about 7 seconds until the indicator light flashes red and blue alternately. And a sound can be heard in the speaker.
4.Once the mobile phone detects the headset, a “BLUETREK X2” message will be displayed. Follow the phone instructions to accept the pairing. The PIN code (or passkey) is 0000, then press “yes” or “ok”.
If pairing success, the indicator light will switch to blue and flashes slowly.
If you haven’t started the discovery mode within 5 minutes, the headset will switch off. You must then switch on your headset and start the pairing again.
Wearing the BLUETREK® X2
For your convenience, the ear loops and the ear hook of BLUETREK® X2 are designed to be removable and can be worn on either ear. BLUETREK®X2, as packaged, is already with the small ear loop that is specially designed for active outdoor use.
To replace with the ear hook:
Simply unsnap the ear loop from the headset by pulling gently at the base of the ear clamp ring.
Snap the ear hook onto the headset by applying gentle pressure on the base of the ear clamp ring.
The ear hook is made of a soft material which can be shaped to fit your ear. Please refer to the above diagram of how it can be adjusted.
Switching the BLUETREK® X2 ON and OFF
Switching BLUETREK® X2 ON
When your headset is off, press and hold the TALK button for about 2 seconds until the blue indicator light is on. A beep (2 tones) can be heard in the speaker. Release the TALK Button.
To check if your headset is ON, press once on the TALK button. If the indicator light flashes blue, it means your headset is ON.
Switching BLUETREK® X2 OFF
When your headset is on, press and hold the TALK button for about 5 seconds until the red indicator light is on after the quick blue flashes. A beep (2 tones) can be heard in the speaker then release the TALK Button.
Making a call
PAGE 4 / 6