GE TAD-732 owner manual Storing a Number in Memory Entering a Pause, Dialing a Stored Number

43-732.fm Page 20 Friday, August 13, 1999 1:42 PM

Storing a Number in Memory Entering a Pause

1.Press MEM on the handset. The TALK indicator flashes.

2.Enter the number and any tone or pause entries (see “Using Tone Ser- vices on a Pulse Line” on Page 19 and “Entering a Pause” on Page 20).

Notes:

•Each tone or pause entry uses one digit of memory.

•If you wait more than 20 seconds to press a key or enter more than 16 digits, the phone sounds three quick beeps. Start over at Step 1.

•To keep your accounts secure, we recommend you do not store your personal access code for services such as bank-by-phone in a memory location.

3.Press MEM, then enter a memory lo- cation number (1–9). A tone sounds to indicate that the number is stored.

To replace a stored number, simply store a new one in its place.

To clear a memory location (leaving it empty), press MEM twice, then press the memory location number you want to clear (1–9).

20

In some telephone systems, you must dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. You can store the access code with the phone number. However, you should also store a pause after the access code to allow the outside line time to connect. To do so, press REDIAL to enter a 3-second pause after entering the access code. For a longer pause, press REDIAL again.

Dialing a Stored Number

To dial a stored number, lift the handset and press TALK. When you hear the dial tone, press MEM, then enter the memory location number for the stored number.

Chain-Dialing Service Numbers

For quick recall of numbers for special services (such as alternate long dis- tance or bank by phone), store each group of numbers in its own memory lo- cation.

When calling special services, dial the service’s main number first. Then, at the appropriate place in the call, press MEM, then enter the memory location number for the additional stored numbers.