Telephone Operation, Basic Memory Programming

Redial Button

Automatically redials last number called (up to 32 digits). If the number was busy or unanswered:

1.Lift the HANDSET.

2.Press [Redial].

TELEPHONE OPERATION

Receiving a Call

1.When your phone rings, pick up the handset and use it like any basic telephone.

2.Hang up the handset to release the telephone line when your conversation is completed.

Dialing a Call

1.Pick up the phone and wait for a dial tone.

2.Press the keypad for the telephone number you wish to dial.

Tone/Pulse Combination Dialing

Combination dialing is useful to subscribers of Pulse (rotary) service who wish to gain access to various low-cost long- distance or automated computer services otherwise not available to them.

1.With the Tone/Pulse switch in the Pulse position, dial the phone number.

2.Pressmode. [*], and your telephone will change to Tone dialing

3.Dial your code/authorization number. When your call is completed, your telephone will automatically return to the

PULSE dialing mode.

NOTE: Combination dialing can also be stored into the memory for one-touch access to your long distance or automated computer service.

BASIC MEMORY PROGRAMMING

The CID110 comes with 10-memory dialing.

NOTE: Your local phone company restricts the time you can have the handset off the base (off-hook).

YOU SHOULD PROGRAM THE CID110 MEMORY WITH THE LINE CORD UNPLUGGED FROM THE WALL, IF YOU ARE GOINGTO PROGRAM MORETHAN ONE PHONE NUMBER.

Pick up the handset, and press [Store] to enter memory store.

Press the keypad to enter the number that you want to program. The LCD on the back of the handset confirms the numbers you entered.

Press [Store].The ‘MEM’ will be displayed on the right corner of LCD.

Press the memory location (0 to 9) on the keypad. The LCD will then return to the ‘Answer-Ready’ mode, and display the total call counter, new call counter, current time and date.

Copy from the Caller ID to Telephone Memory

Press [] or [] until the Caller ID memory location to be copied appears on the LCD. Press [Store] twice to enter memory store. The ‘MEM’ will be displayed on the right corner.

Press the memory location (0 to 9) on the keypad. The LCD will then return to the ‘Answer-Ready’ mode, and display the total call counter, new call counter, current time and date.

If no key is pressed within 20 seconds, the LCD will return to ‘Answer-Ready’ mode.

Repeat the above steps to store a different number in the same speed dial location, or to store a new number in a different speed dial location.

NOTES:

•Pressing [Redial] will place a 4-second PAUSE into the number.Which may be required for accessing special phone services.

•You can store a number with up to 16 digits maximum. Only the last 14 digits will be displayed.

MEMORY DIALING

Pick up the handset to make your call.

Press [MEM] [0] ... [MEM] [9] for one of the 10 memory locations to be dialed.

NOTE: Remember to plug the telephone line cord back into the wall.

CALLER ID OPERATION

NOTE: Batteries must be installed, or Caller ID operations will not work properly (see “To Install Batteries”).

If an incorrect, invalid or incomplete Caller ID signal is received, the LCD

shows ‘-LINE ERROR-’.

If only the caller’s phone number is received, the LCD shows the caller’s phone number with the time and date it

was received. The ‘NEW’ icon turns on and New Call LED blinks.

If both the caller’s name and phone number are received, the LCD shows the caller’s name and phone number with

the time and date it was received. The ‘NEW’ icon turns on and New Call LED blinks.

If the name and number are not available due to the caller’s restriction, the LCD

shows ‘-PRIVATE CALL-’ with the time

and date received. The ‘NEW’ icon turns on and New Call LED blinks.