AT&T 200 manual FCC Regulations and Compliance Issues

Page 32

FCC REGULATIONS AND COMPLIANCE ISSUES

PART 15

Some electronic equipment can generate and radiate radio frequency energy that may cause radio and/or television interference if not installed and used properly. This equipment has been tested and found to comply with the limits for a Class B digital device, as specified in Part 15 of the FCC rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation; however, there is no guarantee that interference will not occur in a particular installation. The user is encouraged to try the following to correct interference that occurs: When possible, re-orient the receiving radio or television antenna.

Increase the separation between this equipment and the antenna of the affected device; or

Connect the equipment to an AC receptacle that is on a different circuit than the affected device.

PART 68

This equipment complies with Part 68 of the FCC regulations. You will find the applicable label on the device. The label contains the FCC registration number and Ringer Equivalence Number (REN) for this equipment. If requested, provide this information to the telephone company. The label also provides the jack type used, which for this equipment is type RJ11.

The REN is used to determine the number of devices that may be connected to a particular line. In most areas, the sum of the RENs should not exceed five (5) for the attached devices to ring properly. To be certain of the number of devices that you may connect to your line, as determined by the REN, you should contact your local telephone company to determine the maximum REN allowed for your area.

In the event that this equipment should fail to operate properly, disconnect it from the telephone line and discontinue its use until it is repaired. Repairs can be made only by the manufacturer.

If any of your telephone equipment causes harm to the telephone network, the telephone company may disconnect your service temporarily. If this is necessary, you will be notified as soon as possible. If this occurs, you will be informed of your right to file a complaint with the FCC. Your telephone company may make changes to its facilities equipment, operations, or procedures that could affect the proper functioning of your equipment. If such changes are to be made, you will be notified.

This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to state tariffs.

29

Image 32
Contents AT&T Table of Contents List of Figures Introduction What’s IncludedMaking the Connections Initialization Error Messages Display DisplayAT&T Voicemail Manager 200 Unit AT&T Voicemail Manager 200 Overview AT&T Voicemail Manager 200 SET UP Keys Using the SET UP Keys Using the Review Keys to Enter DataSET UP Questions Select LANGUAGE? YES/NODisable NEW Message ANNOUNCEMENT? YES/NO SET UP DIALING? YES/NO YOU Dial 10 Digits for Local CALL? YES/NO Set Advanced Options? Yes/No Customizing the AT&T Voicemail Manager AT&T Message Screening Keys Using the AT&T Message Screening Feature Refer to onAT&T Voicemail Manager Access Keys Retrieve Messages with the AT&T Voicemail Manager Keys for Viewing Calls Viewing Calls and Caller Identification Incoming CallsStored Calls AT&T Voicemail Manager 200 Useful Information Keys for Making and Returning Calls Making and Returning Calls Other Display Messages Page Troubleshooting Getting Help FCC Regulations and Compliance Issues Product Warranty WALL-MOUNTING Your AT&T Voicemail Manager Wall Mounting Template This page Intentionally Left Blank Safety Precautions Your Notes Your Notes AT&T Voicemail Manager