
Connection Settings
Never use the following "Connection" menus to change any phone settings unless otherwise in- structed by your carrier. Altering any of these settings may disable Web access capability.
Your phone can have up to 4 sets of the server IP (Internet Protocol) addresses and Port numbers to ac- cess your service provider’s website.These may already be preset or be advised by your service provider.
To change the settings, enter your
Changing IP addresses in “Web Link A”
1. Scroll to “Web Link A” and press F .
2.Enter Link A Primary IP Address and press
3.Enter Link A Primary Port number and press
4.Enter Link A Secondary IP Address and press
5.Enter Link A Secondary Port number and press
F . F
. F
. F
.
Changing IP addresses in “Web Link B”
Scroll to “Web Link B” and press F , and follow the above steps 2 through 5 for Link B.
Notes: 1. An IP address must be
for example, 123.45.67.8, then enter | 1 | 2 ABC 3 DEF , | ||
0 | 4 GHI 5 JKL , 0 | 6MNO 7PQRS , 0 | 0 | 8 TUV . |
2.Your phone may display the stored IP addresses or Port numbers in the above steps. Then press
F to keep them unchanged.
QNC Info.
The “Username” and “Password” are normally blank. The “Auth.Type” is normally set to “None”. Altering any of these settings may disable the Web access.
Packet Info.
To enable accessing with packet mode, the “Username” and “Password” should be programmed as advised by your service provider. The “Auth.Type” is normally set to “Auto”. Altering any of these settings may disable the Web access.
Current Link
This is normally set to “Web Link A”. Altering to “Web Link B” may disable the Web access.
Service
This mode is normally set to “Auto”. Altering to “Packet” or “QNC” may disable the Web access.
68