sunrise surf & talk
Reset button
The reset button is located in the small hole on the left of the telephone jack, when looking at the sunrise surf & talk box from above. Depending upon how long you press the reset button, you can initiate the following actions:
•Restart the sunrise surf & talk box
•Restore the factory settings, also see Restore factory settings (RESET), p. 30.
Buttons
1.This button is used to adjust the brightness of the display.
2.This button switches the device on and off.
3.This button is used to manually connect to a mobile network.
Your sunrise surf & talk box 8
1 2 3
Instructions for use.
Wiring
The sunrise surf & talk box cables can be easily lengthened, if required. You can purchase cable in the lengths you need at a computer or electronics store. Keep the following tips in mind, however, when attaching cables.
•If you wish to connect your computer directly to the sunrise surf & talk box, without using a switch or hub, be sure to use a crossover Ethernet 10/100 BaseT cable with STP («shielded twisted pairs»).
•If you wish to attach your computer to the sunrise surf & talk box via a switch or hub, be sure to use a standard Ethernet 10/100 BaseT cable with STP.
•The cable should be a maximum of 100 m long.
Wireless Local Area Network (WLAN)
The two WLAN standards used today, 802.11b and 802.11g, were developed by the Institute of Electrical and Electronic Engineers (IEEE). Using the 802.11b technology, a transfer rate of up to 11 Mbit/s can be obtained, while the 802.11g standard allows transfer speeds of up to 54 Mbit/s.
The sunrise surf & talk box supports both standards. With a WLAN adapter based on one of the two standards, you can connect to the sunrise surf & talk box. The range of the WLAN depends a lot on the WLAN adapter used, as well as structural considerations of the location of the network. WLAN devices of different standards can be used simultaneously to set up connections with the sunrise surf & talk box.
The sunrise surf & talk box is equipped with an internal WLAN antenna, which is not visible from the outside of the case.