Wiring, Power supply connection, PC connection

7.WIRING

Power supply connection

The following 2 methods are available for supplying power to the station.

0 From a DC 12 V AC adapter

0 From an IEEE802.3af compliant PoE switching hub

(For connection, refer to the instruction manual supplied with the switching hub.)

AC adapter connection

Cable

Connect the AC adapter*. Install the supplied ferrite clamp on the AC adapter cable by winding the cable around the ferrite clamp once

AN-8500MS rear

12V- 4WmA

<>-T-T>

Ferrite clamp (accessory)

*Use the AC adapter AD-121OP(optional)or the equivalent. As for the usable adapter, consult the AIPHONE sales

Off

External speaker connection

Press down the desired push- in terminal button with a tip of

standard driver, and	insert
the cable securely.	11 mm

*Applicable cables are as follows.

Conductor diameter:	COM HOT

00.4- 1.3 mm (AWGI6 - 26), Solid wire

00.7- 1.4 mm (AWGI6 - 22), Stranded wire

0 When using the external speaker, IN-,-.EXT. set the internal/external speaker sp sp switch on the bottom to the EXT.

SP position.

PC connection

Use a UTP category 5 straight- through cable with an RJ-45 connector for this connection.

Can be connected to a network of IOBASE- TI1OOBASE-TX in auto-sensing.

Use a UTP category 5 straight-through cable with an RJ-45 connector for this connection.

8. A	SQRY
CD*	1
Ferrite clamp	...................................................... 1

*Contains the AN-8000 setting software program and the AN-8000 series instruction manual. The Setup Launcher is automatically started when the supplied CD-ROM is inserted into the PC's drive.

Note

If your PC's CD drive is not compatible with the AutoRun function, the setup guide is not automatically started even when the CD is inserted. Use either "Explorer" or "My Computer" to execute the following files, or use [Start -+Run] in the Task Bar and enter the following command.

<Drive where CD is placed> \index.html

For example, when placing the CD in the "d" drive, 4 d:\index.html

AC adapter:	AD-1210P
Wall mounting bracket:	YC-280

-(Version update information

0Please contact to the AIPHONE sales office to obtain

the up-to-date version for firmware, software and the instruction manuals.

0The software version number can be confirmed using

the Help menu.

0The current firmware version can be confirmed on the

system management screen displayed when the browser establishes the connection to the station.

0 The instruction manual version number can be confirmed by checking the preparation date (year and month) shown at the lower right corner of the last

page.

Example: Prepared in July 2006: 200607