Specifcations, Hardware Specifications

Device running / normal operation:

During normal operation, the Green LED will remain on while the Red LED will remain off.

Pushing the reset button:

Upon pressing the reset button, the Green LED and Red LED will remain on. If the reset button is held for 10 seconds or more, the Green LED will remain lit and the Red LED will blink, resetting the unit to factory defaults.

Ethernet jack LED status

Yellow: link is established

Green: connected to 10Mbit network

Orange: connected to 100Mbit network

SPECIFCATIONS

Hardware Specifications:

Input Voltage:	Use Aiphone PT-1211C (included); 15-24V AC/DC
Network Interface:	10/100 Base-T Ethernet (Auto detection) RJ-45
IP Assignment:	Static or Dynamic
Hardware Protocols:	TCP/IP, UDP, DHCP, SNMP, AutoIP, SonicIP, Ipzator
	Contact Aiphone for additional supported protocols
Transport Bandwidth:	≈128Kbps per active session (normal mode)
	≈64Kbps per active session (low bandwidth mode)
Audio Encoding:	PCM (raw), G.7II ( Law)
Audio Sampling:	16bit at 8kHz (normal mode)
	8bit at 8kHz (low bandwidth mode)
Output Level:	Determined by sub station
Relay Contact Rating:	30V AC/DC 1.0A (resistive)

Operating temperature: 32°F to 104°F (0°C to 40°C)

Dimensions:

1-1/2″H x 4-1/4″W x 4-15/16″D

Software System Requirements:

For optimum performance of the CommuniCenter program, we recommend the following minimum requirements:

Operating System:	Microsoft Windows®XP (SP2), Windows Vista ®
Processor:	1 GHz or faster
Memory:	256MB of RAM
Hard drive:	50MB of available disk space
Sound Card:	Windows supported sound card (w/ speaker & microphone)

WARRANTY

Aiphone warrants its products to be free from defects in material and workmanship under normal use and service for a period of one year after delivery to the ultimate user. We will repair free of charge or replace at no charge Aiphone product, that upon examination by an Aiphone Repair Technician is proven defective and under warranty. Aiphone reserves the right to make the final decision whether there is a defect in materials and/or workmanship; and whether or not the product is within the warranty.

This warranty covers bench repairs by the Aiphone Service Department only, and does not extend to units that have been repaired or altered outside of the factory. Aiphone is not responsible for any costs incurred involving on-site service calls. This warranty shall not apply to any Aiphone product that has been subjected to misuse, neglect, accident, power surge, or used in violation of instructions furnished.

Aiphone Communication Systems
1700 130th Ave. N.E.	TOLL FREE TECHNICAL SUPPORT:	Pg. 4
Bellevue, WA 98005
	(800) 692-0200	IPW-1A Instr.
(425) 455-0510
	E-MAIL: tech@aiphone.com	0210Tech
FAX (425) 455-0071