Aiphone LE-SS/LE-SSR/LE-SS-GP manual Brn, Yel Red, MP-S System, AP-M System, Specifications

WIRING DIAGRAMS:

MP-S SYSTEM:

MP-S Master LE-SS(R,-GP) Sub

1

(2)

(3)

E

PS-1225UL

Red

Blk*

Grn

Jumper Green & Black wires together.

Leave brown, orange, and yellow wires disconnected.

+			+
-				-
AP-M SYSTEM:					AP-M Master		LE-SS(R,-GP) Sub
					1			Red	Modifying LE-SS/-SSR/-GP
					E			Blk	to work with AP-M Master:
					2			Grn	1. Cut Brown wire on CP038.
									(Brown wire jumpers J8 to J10.)
					E			Brn
									2. Tie Brown wire from J8 to
								Org	Orange wire on J9.
					~			Brn	3. Tie Brown wire from J10 to
LE-SS/LE-SSR									Yellow wire on J11.
								Yel
	Red				10				Tie Blk and Grn wires together for all
									installations with the MP-S and AP-M
		Blk				E	WIRE DEFINITIONS:		systems.
		Grn
							Red: Hot side of speaker & call switch, connect to # of master
		Brn
							Black: Common communication, connect to E of master
		Org					Green: Negative side of call switch
		Brn					Brown: Call switch, left intact for LEM, LEF.
							Jumpered with Org/Yel for AP-M
		Yel
							Orange: Additional resistor circuit for AP-M

Yellow: Additional resistor circuit for AP-M

Intercom wiring must be run at least 20" away from any AC wiring, fluorescent lighting, dimmer switches, or any other electronic device that may cause interference.

SPECIFICATIONS:

Power Source:	Supplied by master station
Speaker:	20 ohms, 4W, 2.5" diameter, water proof and puncture resistant, 2.4 oz. magnet
Call Button:	SPST call button. Call tone rings at master as long as button is held down. LED will remain lit for approx.
	20 seconds (LEF, LEM-3, MP-3S, AP-5/10M only). Call tone only on LEM-1DL, LEM-1, and MP-1S.
	LE-SS/-GP: Limited stop button. LE-SSR: Limited stop, red mushroom button
Communication:	Hands free at sub. Master is push-to-talk,release-to-listen.
Faceplate:	12 gauge stainless steel
Mounting:	Flush mount into a 2-gang box. Surface mount into SBX-2G, sold separately. Tamper proof screws
	included (6x32 for use with flush gang box) with T-10 TORX bit.
	Use hardware included with SBX-2G when installing sub into that unit.
Terminations:	Color-coded prewired pigtails
Operating Temperature:	Speaker rating: -67°F to 187°F
	LE-SS(G) Switch rating: 14 F to 158°F; LE-SSR Switch Rating: -22 F to 185°F
Wiring:	2 conductors in a 1-master LEF, MP-S, or AP-M system. 3 conductors in a multi-master LEF system.
	Shielded cable is recommended. Use Aiphone #822202 for LEM or MP-S. Use #822202 or
	#822203 for LEF. Use #832202 for AP-M systems.
Wiring Distance:	See system that unit is being used with for distance specifications.
Dimensions (H x W x D):	LE-SS/-SSR/-GP alone: 4-11/16" x 4-11/16" x 2"
	With SBX-2G(-GP2): 4-3/4" x 4-7/8" x 3-5/8" (Top) 2-3/8" (Bottom)

Aiphone Communication Systems

1700 130th Ave. N.E.

Bellevue, WA 98005

(425)455-0510 FAX (425) 455-0071

Toll Free Technical Support:

1-800-692-0200

E-mail tech@aiphone.com

LE-SS(R,GP) Instr. 0909BKJS