Philips SHB9000 manual Order to Do this Sound and LED indicator Feedback

The table below shows how to operate your headset:

In order to:	Do this:			Sound and LED indicator
				feedback
Enter pairing mode	Press	until the LED starts		Alternating red/blue flash
	blinking red / blue alternately
Turn headset on	Press	for 2 seconds		• 3x red flash: battery is low
				• 2x red flash: > 25% of
				charge remaining.
				• 1x blue flash: > 50% of
				charge remaining.
Turn headset off	Hold	for min. 4 sec		One long beep
Play / Pause music	Tap
Stop music	Hold
Skip Fwd/Bwd	Tap	or
FullSound	Hold	and	simultaneously	One short beep: On
	for 4 sec.			Two short beeps: Off
Adjust volume	Tap VOL- or VOL+
Pick up a call / End a call	Tap
Pick up a 2nd call / put other call	Tap
on hold / switch back*
Reject a call	Hold			One long beep
Redial the last number	Double tap			Two short beeps
Activate voice dialing*	Hold	until “beep” sound		One short beep
Mute Mic	Double tap		(during call)	Short beep every five
				seconds until mute is turned
				off.
Transfer call to phone*	Hold			One short beep
Other status indicators:
Connected to Bluetooth device	Blue light flashes every 3 seconds.
(while in standby or while
listening to music)
Ready for pairing	In pairing mode, LED light flashes continuously alternating red
	and blue.
On but not connected	Blue light flashing fast.
In call	While call is ringing, blue light flashes fast (twice per second).
	After call pick up, slows down to once per second.
Low battery	LED will flash red instead of blue. A short double beep will
	be heard every minute with five minutes or less of talk time
	remaining.

* Available if supported by your mobile phone

E N G L I S H

11