Rear .PANEL Connectors, Actual INSTAllATION

3.The front panel can be fully reversed to provide for optimum viewing area, operat- ing for any mounting position. (See page 7 ).

4.The EXTERNAL speaker jack may be used with an auxiliary speaker in lieu of the built-in speaker.

5.All connections are "plug-in" type for easy removal of the radio.

ACTUAL INSTAllATION

After carefully considering the various factors affecting choice of location, position the radio (with bracket, microphone, power plug, antenna plug and any auxiliary plugs installed) into the selected location to assure there is no interference with surrounding items. Mark the location of the mounting bracket. Remove the bracket from the radio and use it as a template to mark the holes to be drilled for the mount-. ing hardware. Drill the holes and mount the bracket with hardware compatible with

th,e material of the mounting surface. Install the power cable (red is +, black is -), antenna and all other auxiliary cables and accessories. Install the radio into the

mounting bracket and connect all cables and accessories to the appropriate jacks and connectors.

REAR .PANEL CONNECTORS

CD @ @ @ @ @

1.EXTERNAL SPEAKER CONNECTOR--If it is desired to use a speaker other than

the one in the radio, a four or eight ohm speaker eq.uipped with a miniature phone plug may be connected to this jack. The internal speaker is disabled when an \I external speaker is used.

2.INTERCOM CONNECTOR--When using the intercom feature, a four or ei~ht ohm

speaker with a miniature phone plug should be connected to this jack. Refer to the section for intercom operation.

-3-