Mounting the Phone, Using the Phone | Radio Shack ET-293 specification

MOUNTING THE PHONE

Desk Mounting

Wall Mounting

(With or Without Wall Plate)

(Screws not supplied)

Handset Holder

(Wall Mounting)

USING THE PHONE

Adjust the handset’s vol- ume as desired.

Set to TONE or PULSE to match the type of service you have.

If you have pulse (rotary) service, you can switch to TONE during a call to use tone services.

Use a paper clip or other pointed object to lift the plastic cover off the number plate. Then write your phone num- ber(s) on the number plate and replace the cover.

Note: Use a pencil in case the number changes.

Use CONF to make a confer- ence call. See “Making a Con- ference Call.”

The green indicator next to LINE 1 or LINE 2 lights to show which line is ringing.

Set the volume for each line’s ringer. Set to HI in a noisy room or LO in a quiet room. To turn off the ringer, set it to OFF. You can still make calls with the ringer off, and you can also receive calls, if you hear another phone on the same line ring.

Note: The USOC number of the jack to be installed is RJ11C or RC14C (RJ11W for a wall jack).

Plug the handset cord into the jacks on the base and handset.

Press RESET to end a call without hanging up the handset.

Press REDIAL to dial the last number dialed (up to 31 tone or 32 pulse dig- its).

Press HOLD to place a call on hold. When the line’s red indi- cator lights, you can place the handset on the cradle. To return to the call, press that line’s but- ton or pick up any extension phone on that line.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol is intended to inform you that parts inside the telephone present a risk of electric shock.

This symbol is intended to alert you to important operating and servicing instructions included in the papers with the telephone.

MAKING A CONFERENCE CALL

1.	Place a call to one of the parties.		To talk on only one line without disconnecting the
2.	Press HOLD to put the first call on hold.		other line, press HOLD to put both lines on hold. Then
			press the button for the line you want to talk on. To
3.	On the other phone line, place a call to the other
			return to the three-way conversation, press CONF.
	party.
			To disconnect one line and continue talking on the
4.	After the second party answers, press	CONF to
			other, press the button for the line you want to talk on.

connect all three parties.

ÐÐ

Radio Shack is a registered trademark used by Tandy Corporation.