Programming
Programming using the direct commands
1
2
3
4
{MENU}
Enter the desired feature code.
Enter the desired setting code.
LThis step may vary depending on the feature being programmed.
{Save} i{OFF}
Note:
LIn the following table:
–< > shows the default setting.
–If “System setting” column is checked, you do not need to programme the same item using another handset (KX- TG2622).
LIf you make a mistake or enter the wrong code, press {OFF}, then start again by pressing {MENU}.
Feature | Feature | Setting code | System |
| code |
| setting |
Auto talk*1 | {0}{3} | {1}: On {0}: <Off> | – |
Copy phonebook (1 item)*2 | {#}{1} | (page 23) | – |
Copy phonebook (All items)*2 | {#}{2} | (page 23) | – |
Dial lock | {6} | (page 20) | r |
Interrupt tone*3 | {1}{3} | {1}: On {2}: <2> {0}: Off | – |
Key tone*4 | {0}{2} | {1}: <On> {0}: Off | – |
LCD contrast | {0}{1} | – | |
(Display contrast) |
|
|
|
Registration | {0}{0} | (page 33) | – |
Ringer tone (Handset) | {1}{2} | – | |
|
|
| |
Ringer volume (Handset) | {1}{1} | {1}: Low {2}: Medium | – |
|
| {3}: <High> {0}: Off |
|
Set area code | {0}{4} | (page 25) | – |
Set dial mode | {0}{5}{1} | (page 39) | r |
29