Panasonic KX-TG8070E manual Frequently asked questions, Question Cause & solution

TG8070_TG8090E(e)_QG.fm Page 5 Wednesday, May 30, 2007 11:23 AM

Frequently asked questions

Question	Cause & solution
Why is w flashing and	LThe handset is cancelled. If you want to register the
“Register!” is shown on the	handset to the base unit(s), follow “Registering a handset
handset display?	to a base unit”, page 6. If you want to use a base unit(s)
	which was registered to the handset before cancellation,
	select it by following “Selecting a base unit” in the
	operating instructions.
Why is w flashing and	LThe handset is too far from the base unit. Move closer.
“Searching...” is shown on the	LThe base unit AC adaptor is not connected. Check the
handset display?	connections.
	LYou may have selected the wrong base unit. Select the
	right base unit.
	LYou are using the handset or base unit in an area with high
	electrical interference. Place the handset and base unit
	away from interference sources, such as antennas and
	mobile phones.
Why is the handset display blank?	LThe handset is in screen saver mode. If charging, lift the
	handset to activate the handset display again. If the
	handset is not on the base unit or charger, activate the
	handset display again by:
	– pressing {^} or {V} when on a call or operating the
	answering system
	– pressing {i} for all other times
	L“Dimmed Backlight” is set to “Off”. Change the
	setting.
Why can I not make calls?	LThe dialling mode setting is incorrect. Set to “Tone” or
	“Pulse” as needed.
What should I do when the handset	LMake sure that the batteries are installed correctly.
does not turn on?	LFully charge the batteries.
	LClean the charge contacts and charge again.
How long is the battery operating	LWhen you are using fully-charged Ni-MH batteries
time?	(supplied batteries);
	In continuous use: 10 hours max.
	In continuous standby mode: 100 hours max.
	LIt is normal for batteries not to reach full capacity at the
	initial charge. Maximum battery performance is reached
	after a few complete cycles of charge/discharge (use).
	LActual battery performance depends on a combination of
	how often the handset is in use and how often it is not in
	use (standby).
Can I keep the handset on the base	LEven after the handset is fully charged, the handset can be
unit or charger when I am not using	left on the base unit or charger without any ill effect on the
it?	batteries.
When should I replace the batteries?	LIf the batteries are fully charged until @is displayed, but /
	is displayed after a few calls, replace the batteries with
	new ones.

– 5 –