Panasonic KX-TCD150E operating instructions Troubleshooting, Problem Cause & solution

TCD150E(E).book Page 14 Wednesday, May 25, 2005 4:58 PM

Useful Information

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.

Problem		Cause & solution
w is flashing.		LThe handset is too far from the base unit. Move
			closer.
		LThe AC adaptor is not connected. Check the
			connections.
		LYou are using the handset or base unit in an area
			with high electrical interference. Locate the
			handset and base unit away from interference
			sources, such as antenna and mobile phones.
		LThe handset registration is cancelled. Register the
			handset to the base unit using the following
			method.
			1 {j/OK}
			2 “SETTING HS” i{>}
			3 “REGISTRATION” i{>}
			4 “REGISTER HS” i{>}
			5 Press and hold {x} on the base unit until the
			registration tone sounds.
			LThe rest of the procedure must be completed
			within 1 minute.
			6 Select a base unit number ({v}). i{>}
			7 Wait until “BS PIN” is displayed. iEnter
			base unit PIN (default: “0000”). i{>}
			LA confirmation tone will sound, and w will
			stop flashing.
I cannot make or receive calls.		LThe AC adaptor or telephone line cord is not
			connected. Check the connections.
		LThe call bar feature is turned on. Turn it off (page
		10).
		LYou dialled a call restricted number (page 12).
		LThe key lock feature is turned on. Turn it off (page
		8).
The unit does not ring.		LThe ringer volume is turned off. Adjust the ringer
			volume (page 10, 11).
The handset display is blank.		LThe handset is not turned on. Turn the power on
			(page 5).
14	Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333