Panasonic operating instructions Installing the Panasonic KX-T7775 Doorphone

Installing the Panasonic KX-T7775 Doorphone

The Panasonic KX-T7775 Doorphone can be surface or flush-mounted.

To surface-mount the Panasonic KX-T7775 Doorphone Module:

1.Separate the Doorphone Unit into two halves.

2.Adjust the sensitivity of the Doorphone's microphone, if required (see page 11).

3.Remove the required pop-outs on the back of the Unit and slide the wires through the back of the Unit. Connect to the Doorphone's terminal block.

4.Secure the Unit to the wall using the appropriate screws (not supplied).

5.Re-connect the front panel to the back unit using the supplied 10 mm (3/8") M3 threaded screws.

To flush-mount the Panasonic KX-T7775 Doorphone:

1.Separate the Doorphone Unit into two halves. Discard the rear section of the Unit.

2.Adjust the sensitivity of the Doorphone's microphone, if required (see page 11).

3.Attach the gasket to the rear of the interface bracket, as shown in Figure 8. (The gasket side faces the wall.)

4.Gang-box only: Attach the interface bracket to the gang-box using screws (not supplied) (see Figure 9).

Recessed only: Attach the interface bracket to the wall using the appropriate screws (this is dependent on the surface structure) (see Figure 10). Refer to the mounting template, on page 15, for drilling positions.

Rear View

Figure 8 Figure 9

9