Operating the built-in answering device
Operating the answering device from a remote location
light on
Preparation: Programming the remote operation ID
1.Press 
(Function).
2.Press 
.
3.Enter any
or #.
Example : 留守電暗証番号 ?
1234
4.Press 
(Set).
5.Press 
(Stop).
Operation: Listening to a recorded message from a remote location
Turn the 
(Auto answer) light on before you go out. Remote operations are available only from a touch tone telephone.
1.Call your unit.
2.Enter the remote operation ID during the greeting message.
3.Press 2 or wait 4 seconds.
Only the new recorded messages will be played back.
To listen to all the recorded messages, press 4 after the new messages have been played back.
Night mode
Turn on the night mode
light on
Press 
(Night mode) for about 3 seconds.
“ 
” is displayed and 
lights on.
When a call is received during night mode, the unit will handle the call silently, either by storing the received fax into memory or by recording the caller’s message.
Night mode allows you to select a block of time during which the unit will not ring for outside calls or make sounds when you change the settings. This feature is useful when you do not want to be disturbed, for example, while sleeping.
Listening to recorded messages
When new messages are recorded, the 
(Auto answer) light will flash.
Press 
to listen to recorded messages.
After the messages are played back, the following will be
displayed.再生した用件を 消去しますか？
To erase the messages, press 
(Yes).
To save the messages, press 
(No).
Printing received fax documents
When new faxes are received, the 
light will turn on.
To print the faxes, see "Printing a specfic fax stored in memory" on page 18.
Turn off the night mode
Press 
(Night mode) for about 3 seconds.
20