RJ31X Adapter, For USE with | Linear instruction

RJ31X ADAPTER

FOR USE WITH

THE PERS CONSOLES installation instructions

(760) 438-7000

USA & Canada (800) 421-1587 & (800) 392-0123

Toll Free FAX (800) 468-1340

www.linearcorp.com

To provide proper telephone line seizure this cable must be connected to an 8-position telephone jack installed per FCC Universal Service Order Code RJ-31X or RJ-38X. See Figure 1 for details of the telephone jack wiring.

A single ended 8-conductor modular line cord is used to connect the PERS console to the telephone jack. Plug the LINE and PHONE plugs into the appropriate jacks on the PERS console. See Figure 2. Route the cable away from the jacks via the internal raceway. Then install the 8-position plug into the telephone company jack.

Testing

Test the PERS console by ﬁrst calling the central station and informing them that a test is going to be performed.

Trigger an alarm via the remote control or from the large EMERGENCY/HELP button on the console.The house phones will be disconnected and the central station will recieve the emergency message. If the console is equipped with two-way voice capability the central station may talk via the console to verify proper operation of the two-way voice system.

After the PERS console goes ofﬂine, the house phones will be restored to normal operation.

TO "LINE"

JACK ON

PERS CONSOLE

8-PIN

MODULAR

PHONE CORD

8-POSITION

1
2
3		TO "PHONE"
	4

5		JACK ON
6		PERS CONSOLE

OTHER WIRES

NOT USED

Example with	TELEPHONE
PERS-2400A	JACK (RJ31X
PERS-2400A	OR RJ38X)
	CONSOLE WITH
	REAR COVER
	INSTALLED

USOC RJ31-X (OR RJ38-X)

JACK

TO TELEPHONE NETWORK

Figure 1

	R1		R		T		T1
								SHORTING BAR
								SHORT REMOVED
1	2	3	4	5	6	7	8	ON PLUG
1	2	3	4	5	6	7	8	INSERTION
R								T1
T
								R1
								TO LOCAL
								TELEPHONE
								SETS

ROUTE CABLES UNDER
STRAIN-RELIEF TABS
(PHONE)
CONNECT LOCAL	(LINE)
TELEPHONE TO	(LINE)
THIS JACK	CONNECT TELEPHONE
	LINE TO THIS JACK
Figure 2

221329 B