FastHome™
Pre-Installation Instructions
1.After the enclosure has been mounted, determine which modules will be inserted. On a sheet of paper, diagram the location where each module will be placed. An expansion module should be placed close to the module with which it interfaces.
2.On the diagram, identify the origin and destination of each cable. Make sure the module serving each device is safely within a 100ft/30m distance.
Installation Instructions
1.Identify the enclosure location on which the module will be mounted.
2.Mount the module by inserting the nylon pins into the holes in back of the enclosure and pressing the pins in. Make sure that the pins are firmly seated and the module is secure.
Wiring Instructions
Note: Module wiring should only be performed by a experienced, licensed electrician. Make sure all power has been shut off to the equipment and there is no live circuit. Route all cables through the
1.Route Category 5 phone cables from the network interface device at the phone company’s demarcation point to the module.
2.Using a wire stripper, strip off about 2˝ of the cable to expose the wires. Separate the four wire pairs.
3.Using a standard 110 punchdown tool, terminate the tip and ring wires at the “from telcom” side of the telephone hub. Match each wire pair with the color codes on the IDC block (white/blue: blue pair in line one; white/orange: orange pair in line two; white/green: green pair in line three; white/brown: brown pair in line four).
4.Perform the stripping and punchdown function for wires at the “output” side of the telephone hub, for
5.Tag each cable in the module with its point of destination.
6.Route the cables from the hub to the phone/fax/modem locations in the home and termi- nate accordingly.
Security System:
This FastHome™ module offers a connection to the security system that can override any phone in use and alert the security service provider of an emergency. To enable this function, connect the security system cable to the module’s
Installation
Sample configuration for telephone, audio/video, security and Ethernet.
For More Information about FastHome™ and Fast Media Home Network Systems, contact:
Steren Electronics International, LLC 8675 Miralani Drive
San Diego, CA 92126
Copyright © 2004
Steren Electronics International, LLC
Printed in China
R
Fast Media Home Network Systems Revised 06/04