Listening To The Radio
Digital Radio Frequency Display
This clock radio features a digital radio frequency display instead of a dial scale to make tuning easier, especially in a dark room. The jumbo LED time display automatically changes to a radio frequency display as soon as you begin turning the TUN. (Tuning) control. And the display automatically changes back to the correct time within 10 seconds after you release the TUN. (Tuning) control.
1.) Set the Band FM/AM selector switch to the desired band, AM or FM.
2.) Press the POWER button to turn the system ‘On’. The display will briefly show “rd” to confirm that the Radio mode is selected. The AM or FM frequency will appear.
3.) Turn the TUNING control
Important: It is not necessary to tune to the exact frequency of your desired station. Just rotate the TUN. (Tuning) control until you find the strongest signal and the best reception, even if the frequency number on the display is higher or lower than the actual station frequency.
Within 10 seconds after you release the TUN. (Tuning) control the display automatically changes back to the correct time.
4.) Press the VOLUME + ( ) or VOLUMN - ( ) buttons to set the volume to the desired level. The display changes to the volume level indication when you press the volume buttons. The adjust range is from “0” (Minium) to “32” (Maximum).
5.) When you are finished listening, press the POWER button to turn the radio ‘Off’.
13
iC172 IB 301207new3.p65 | 13 |
26/3/2008, 11:11