Operation
Mode Functions
|
|
|
|
Introduction | Operation | Customer Assistance | Warranty |
Mode/Lock Button | The current sensitivity level is displayed |
| with letters “LE” and a Number 01 |
| through 05, with Number 05 being the most |
| sensitive level and Number 01 |
| being the least sensitive level. |
6. Choose one of the following: |
a. Press the Channel Up or Channel Down button to select |
a CTCSS privacy code (01 through 38) for the channel. |
b. Press the Enter/Hi•Low button to switch from CTCSS to |
DCS. The DCS icon and privacy code numbers will flash on the |
VOX Sensitivity Level
Channel Buttons |
2.Press the Channel Up or Channel Down button to change the setting.
3.Choose one of the following:
a.Press the Mode/Lock button to enter the selected setting and proceed to other functions.
b.Press the Enter/Hi•Low button to enter the selected setting and return to Standby mode.
display. The Channel Up or Channel Down button can then be |
used to select a DCS privacy code (01 through 83) |
for the channel. |
If “OFF” flashes in place of the privacy code numbers, |
a privacy code is already set in the opposite (CTCSS |
or DCS) system. Press the Channel Up or Channel Down |
button to cancel the opposite code and select a privacy |
code from the active system for the selected channel. |
7. Choose one of the following: |
10 Memory Locations | • | |
Your microTALK radio has 10 Memory Locations for storing | ||
| ||
your most frequently used channels and channel/privacy code |
|
combinations. These Memory Locations can be selected individually or can be scanned. (See page 18 for memory location scan.)
To program a memory location:
1.Press the Mode/Lock button until the
Mode/Lock Button | Memory icon and the Memory Location |
| flash on the display. |
2. Press the Channel Up or Channel Down button to select the memory location
a. Press the Enter/Hi•Low button to enter the channel/privacy code |
in the selected memory location. Radio then proceeds |
to next memory location, which will blink. |
b. Press the Mode/Lock button to enter the channel/privacy |
code in the selected memory location and proceed to other |
functions on the channel/privacy code displayed before you |
entered mode functions. |
c. Press the Talk button to enter the channel/privacy code |
in the selected memory location and exit mode functions. |
Upon release of the Talk button, the radio will enter |
Memory Icon
(0 through 9).
Standby mode on the channel/privacy code just entered. |
If a location has been programmed before, its associated channel/privacy code will be shown on the display.
Mode/Lock Button
To recall a stored memory channel location:
1. Press the Mode/Lock button until the Memory |
icon and the memory location number flash on |
Channel Buttons |
3.Press the Enter/Hi•Low button to enter a new memory location or edit an already programmed memory location. The channel numbers will flash on the display.
4.Press the Channel Up or Channel Down button to select a channel (1 through 22).
5.Press the Enter/Hi•Low button. The CTCSS icon and privacy code numbers will flash on the display.
Memory Icon |
the display. |
2. Press the Channel Up or Channel Down button |
to select a memory location |
(0 through 9). |
If a location has been programmed before, its associated channel/privacy code will be shown on the display.
12 | 13 |