Operation | Mode Functions |
| |
Channel Buttons | 3. Press the Talk button to return to Standby |
| mode on the selected memory location. |
| A memory location can be reprogrammed |
| at any time it is displayed. Press the |
| Enter/Hi•Low button to begin. |
While recalling a stored memory location, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.
|
|
|
|
Introduction | Operation | Customer Assistance | Warranty |
While
Channel Scan
•
Your microTALK radio can automatically scan channels.
Mode/Lock Button To scan channels:
1. Press the Mode/Lock button until the |
Scan icon and the channel numbers |
Mode/Lock Button
Memory Icon |
To de-program a memory location:
1.Press the Mode/Lock button until the Memory icon and the memory location flash on the display.
2.Press the Channel Up or Channel Down button to select the memory location (0 through 9).
If a location has been programmed before, its associated channel/privacy code will be shown on the display.
Scanning Channels |
Channel Buttons |
flash on the display. |
2. Press the Channel Up or Channel Down |
button to begin scanning channels. |
The radio ignores specific privacy codes while scanning channels.
The Scan icon will continue to be displayed when scan is on. Your radio will continue to scan all channels and stop if an incoming transmission is detected. Your radio will remain on that channel for 10 seconds.
Channel 0
3.Press the Enter/Hi•Low button. The channel numbers will flash on the display.
4.Press the Channel Up or Channel Down button to select Channel 0.
5.Choose one of the following:
a.Press the Enter/Hi•Low button to enter the channel/privacy code in the selected memory location and return to the beginning of memory location options.
b.Press the Mode/Lock button to enter the channel/privacy code in the selected memory location and proceed to other functions on the channel/privacy code displayed before you entered mode functions.
While setting channel scan, if you do not press any buttons for
15 seconds, your radio will automatically return to Standby mode on the channel or channel/privacy code displayed before you entered mode functions.
During channel scan (while receiving an incoming transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that channel. Your radio will remain on that channel and return to Standby mode.
b. Press the Channel Up or Channel Down button to resume scanning channels.
If you press the Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on the channel on which you last received a transmission. This will return the radio to Standby mode.
|
|
|
|
14 English | Nothing Comes Close to a Cobra® 15 | ||