Using Your Radio
Operation
|
|
|
|
Introduction | Operation | Customer Assistance | Warranty |
On/Off Power
Battery Low
Turning on Your microTALK® Radio •
To turn on your radio:
1.Rotate the On/Off Volume knob clockwise to turn on your radio and adjust the volume. A series of tones will indicate the radio is on.
Your microTALK® radio is now in Standby mode, ready to receive transmissions. The radio is always in Standby mode, except when the Talk, Call or Mode/Lock buttons are pressed.
Battery Low
•
Your microTALK® radio has a battery level meter that shows when battery power is decreasing. The greater the number of bars visible, the stronger the battery level. When the battery level is low, the last bar and “bALo” will flash
Talk Button
Five cm (two inches) from Mouth
Communicating with Another Person • To talk to another person:
1.Press and hold the Talk button.
2.With the microphone about five cm
(two inches) from your mouth, speak in a normal voice.
3.Release the Talk button when you are finished talking and listen for a response.
You cannot receive incoming calls while pressing the Talk button.
Both radios must be tuned to the same channel/privacy code to communicate.
indicating your batteries should be replaced or, if using rechargeable batteries, recharged.
Channel Buttons
Channels
•
To select a channel:
Battery Save Mode |
| Auto Battery Save | • |
|
| Your microTALK® radio has a unique circuit | |
|
|
| |
|
| designed to extend battery life. If there are |
|
|
| no transmissions for 10 seconds, the radio will |
|
|
| automatically switch to Battery Save mode and |
|
|
| the Power Saver icon will flash in the display. |
|
|
| This will not affect the radio’s ability to receive |
|
|
| incoming transmissions. |
|
Channel Number
1.With the radio on, select any of the
22 channels by pressing the Channel Up or Channel Down button.
Both radios must be tuned to the same channel to communicate.
Channels 1 through 7 are shared by FRS and GMRS. Channels 15 through 22 are GMRS only. Channels 8 through 14 are FRS only.
See page 20 for FRS/GMRS frequency allocations and compatibility charts.
Listening
Listening for a Response
When you are finished talking:
•
2 English
1.Release the Talk button to receive incoming transmissions. Your microTALK® radio is always in Standby mode while the Talk or Call buttons are not pressed.
Nothing comes close to a Cobra® 3