Cobra Electronics HH 38 WX ST Operation, Attach Antenna, Battery Installation, Attach Belt Clip

Operation Operation

Attach Antenna

Note

To increase range as a portable, use CA41 telescopic loaded long range antenna. (See Accessory Page 35).

Attach Antenna

1Insert.

Install Batteries

Press and hold down on arrow and slide

Battery

Installation

Note

Ignoring polarity markings (+/-) can cause damage to both the unit and the batteries.

The HH 38 WX ST requires 9 “AA”alkaline or NiCD batteries (not included with the unit).

1 Remove battery chamber cover. Press down on

					arrow and slide.
				2 Install batteries by polarity markings.
				3	Replace cover.
					NiCD rechargeable batteries
				2 Turn clockwise. 1⁄4 turn.	should be charged a minimum
		FUNC			of 12 hours with a CA-45C
		PWR SAVE WX			charger.
		SIGNAL
		SCAN DW EMG
		POWER
Lock	Pwr Saver	DW
	40		Func
	CB/WX	CH9/19	Scan	Attach Belt Clip

When batteries are low or need charging the BATTERY icon will flash on the LCD display. Replace alkaline batteries or recharge NiCD batteries.

NiCD rechargeable batteries should be charged a minimum of 12 hours with a CA-45C charger.

NiCD rechargeables should have a rating of 1.2 vdc,750 Mah.

Attach Belt Clip

Note

Clip slides up to attach and slides down to remove.

1 Slide belt clip up on	2 To remove belt clip,
rails of base until	lift tab out and slide
tab locks.	belt clip down.
2	3