Cobra Electronics CXT450 Using Your Radio, For charging microTALK radios in desktop charger

Page 4
1. Press and hold the Talk button.
2. With the microphone about 2 inches (5 cm) from your mouth, speak in a normal voice.
3. Release the Talk button when you are finished talking and listen for a response.
You cannot receive incoming calls while pressing the Talk button.
Both radios must be tuned to the same channel/privacy code to communicate.
Your microTALK radio has a unique circuit designed to extend battery life. If there are no transmissions for 10 seconds, the radio will automatically switch to Battery Save mode and the Power Saver icon will flash in the display. This will not affect the radio’s ability to receive incoming transmissions.
Signal Strength Meter
Your microTALK radio has a Signal Strength Meter that shows the strength of your incoming and outgoing transmissions. The ascending bars next to the signal strength indicate the strength of the signal. The greater the number of bars visible, the stronger the signal. The fewer number of bars visible, the weaker the signal.
Communicating with Another Person
•
•
•

Operation

Insert Radio(s)

Using Your Radio

For charging microTALK radio(s) in desktop charger:

1. Insert radio(s) into desktop charger as shown.

2. Insert round connector of 120-volt adapter into jack on back of charger.

3.Plug 120-volt adapter into electrical outlet.

 

 

 

 

Introduction

Operation

Customer Assistance

Warranty

On/Off Power

Turning on Your microTALK Radio

 

Rotate the On/Off Volume knob clockwise to turn•

 

on your radio and adjust the volume. A series

 

of tones will indicate the radio is on.

 

Your microTALK radio is now in Standby mode,

 

ready to receive transmissions. The radio is

 

always in Standby mode, except when the Talk,

 

Call or Mode/Lock buttons are pressed.

If charging light is not on, check position of radio. Radio should be upright. The charge indicator light will stay on as long as the radio is in the charging well, even after the batteries are fully charged.

It normally takes about 15 hours to fully recharge batteries. Batteries will not be damaged if they stay in the charging well longer than that.

Note: To charge a single radio, you can bypass the desktop charger and simply insert the wall adapter’s round connector directly into the speaker/microphone/charge jack located on the top of the radio.

Use only the supplied rechargeable batteries and charger for recharging your Cobra microTALK radio.

Cobra recommends your radio is turned off while being charged. Non-rechargeable alkaline batteries can also be used in your radio.

Quick Start

1.Rotate the On/Off Volume knob to turn on your radio.

2.Press the Channel Up or Channel Down button to select a channel.

Both radios must be tuned to the same channel/privacy code to communicate.

3.Press and hold the Talk button while speaking into the microphone.

4.When finished talking, release the Talk button and listen for a response.

2

Battery Low

 

Battery Low

•

 

 

 

 

 

 

 

 

 

 

When battery power is low, the Battery Low icon

 

 

 

 

 

 

 

 

 

 

will blink. Your batteries should be recharged or

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

replaced if using alkaline batteries.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Auto Battery Save

 

Battery Save Mode

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Signal Strength

Talk Button

Two Inches (5 cm) from Mouth

3

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Making Life Easier and Safer For Assistance in the U.S.AAutomated Help Desk Customer Assistance OperatorsSafety Information for microTALK Radios Product FeaturesPower Inverters Accessories To install or replace batteries Caring for YourmicroTALKRadioRechargeable Batteries and Desktop Charger Estimated operation time on full charge 12 hoursUsing Your Radio Battery LowAuto Battery Save For charging microTALK radios in desktop chargerSelectable HighLow Power Output VolumeListening for a Response Call ButtonTo turn the lock feature on or off Enter/HiLow PowerLight/Max Range To briefly turn off auto squelch To turn maximum range extender onMode Functions Scrolling through Mode FunctionsSet Ctcss Privacy Codes Mode/Lock Button To select a Ctcss privacy codeMode/Lock Button To turn VOX mode on or off Standby modeMode/Lock Button To select a DCS privacy code Mode/Lock Button To listen to All Hazards Radio channelsTo program a memory location Memory LocationsTo recall a stored memory channel location Channel Scan To de-program a memory locationFlash on the display ThroughPrivacy Code Scan Press and hold the Talk button to communicateIf you press the Talk button while scanning, but more than To scan privacy codesCall Tone Settings To change a call tone settingMemory Location Scan To scan memory locationsTo turn roger beep on or off Mode Functions General SpecificationsTo change keystroke tones Product Service Questions FCC Licensing Product Service QuestionsSend the entire product Warranty and Trademarks Limited One-YearWarranty on Radios & ChargerPlease contact your local dealer for warranty information Trademark Acknowledgement

CXT450 specifications

The Cobra Electronics CXT450 is a powerful and reliable two-way radio that stands out in the crowded market of personal communication devices. Primarily designed for outdoor enthusiasts, this device offers a range of features and technologies that enhance communication over long distances, making it especially useful for activities like hiking, camping, and off-roading.

One of the key features of the CXT450 is its impressive range. With a coverage area of up to 37 miles in optimal conditions, this radio allows users to stay in touch with friends and family over significant distances. However, it is essential to note that actual range may vary depending on the terrain and environmental factors. The device operates on 22 FRS/GMRS channels, providing ample options for clear communication.

Equipped with a built-in NOAA Weather Radio, the CXT450 ensures that users are always informed about changing weather conditions. This feature is particularly valuable for outdoor adventurers who need to monitor the weather closely to ensure safety. The radio can receive alerts for severe weather conditions, helping users to stay prepared.

The Cobra CXT450 also integrates advanced technology, such as the Vox functionality, which allows for hands-free operation. This is especially useful when multitasking or when your hands are occupied, making communication effortless and safe. Additionally, the device features a high-quality speaker and a powerful microphone to ensure clear audio transmission, even in noisy environments.

Moreover, the CXT450 has been designed for durability, featuring a rugged, water-resistant casing that can withstand the elements. This means it can be taken on challenging outdoor excursions without the fear of damage from moisture or impacts. Its compact size makes it easy to carry, while the belt clip ensures it can be secured conveniently.

Another notable characteristic is the extended battery life. The CXT450 can operate on either regular AA batteries or rechargeable NiMH batteries, providing flexibility for extended trips without access to power sources. It also features battery-saving options to prolong usage, making it ideal for prolonged adventures.

Overall, the Cobra Electronics CXT450 combines excellent communication range, essential weather alert features, and a robust design to cater to outdoor enthusiasts and everyday users alike. Its balance of functionality and durability makes it a top choice for anyone seeking a reliable two-way radio for various activities.
Top Page Image Contents