O P E R AT I O N | ENGLISH |
ENGLISH | O P E R AT I O N |
Programming Memory
5. Press the MODE
Recalling Memory Locations | To scan main channels: |
Locations
Your microTALK® radio has 10 memory locations
1. Push the MODE |
| |
button until the | MODE | |
Memory icon and | ||
button | ||
the memory | ||
| ||
location flashes. |
|
2. Select the memory | CHANNEL SELECT | |
location you wish | ||
button | ||
to change by |
| |
pushing the |
| |
CHANNEL SELECT |
|
button up or down. (NOTE: You must press the channel button before programming a memory location.)
3.Press and release the MODE button again. The Memory icon and the main channel number will flash.
4.Select the main channel you wish to store by pushing the CHANNEL SELECT button up or down.
button again to store the main channel in memory and move to
privacy code selection. The privacy code number begins flashing and the Memory icon continues to flash.
6.Select the privacy code
7. Press the ENTER button to program
your selection. You may also press the
TALK button to
transmit your selected channel and privacy code, which will be stored into the memory location you are using. (NOTE: To “unprogram” a memory location you programmed previously, select 00 for both the main channel and privacy code in steps 4 through 6.)
8.Press and release the ENTER button to return to Standby mode at your new memory location, or press and release
the MODE button to save the memory location and proceed to other functions.
To recall a channel you have stored in a memory location:
1. Press the MODE |
|
button until the | MODE |
Memory icon and | |
a memory | button |
| |
location flashes. |
|
2.Select your
desired memory | CHANNEL SELECT |
location by | button |
| |
pushing the |
|
CHANNEL SELECT |
|
button up or |
|
down. Press the | ENTER |
ENTER button | button |
| |
to select your |
|
memory location |
|
channel. You will |
|
now be in Standby Mode on that channel.
3.Repeat steps 1 and 2 to recall other memory locations.
Using the Scan Function
Your microTALK® radio can automatically scan main channels
1.Press the MODE button until the Scan icon and main channel number flashes.
2.Push the CHANNEL SELECT button up or down and the unit will begin scanning the main channels. (NOTE: The unit “ignores” privacy codes while scanning main channels.)
3.The radio will continue to scan all main channels and stop if an incoming transmission is detected. The unit will remain on that channel for 10 seconds. During that time you can:
a)Press and hold 
the TALK button | TALK button | |
and talk. The radio | ||
| ||
will remain on that |
| |
channel and return |
| |
to Standby mode. |
|
b)Push the CHANNEL SELECT button up or down to resume scanning main channels.
c)Press the MODE button to proceed to privacy code scanning (see following page).
If you do not press any button within 10 seconds, the radio will automatically resume scanning main channels.
9 | 10 |