Mode Functions
Operation
While setting privacy code scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code that was displayed before you entered mode functions.
During privacy code scan (while receiving an incoming transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that channel/privacy code. Your radio will remain on that channel/privacy code and return to Standby mode.
b. Press the Channel Up or Channel Down button to resume scanning privacy codes.
If you press the Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit
|
|
|
|
Introduction | Operation | Customer Assistance | Warranty |
Memory Location Scan
•
Your microTALK® radio can automatically scan up to 10 programmed Memory Locations.
If there are one or fewer memory locations programmed in your radio, the scan memory locations option will not be available. To program at least two memory locations, see program memory locations on page 11.
Mode/Lock Button To scan memory locations:
1.Press the Mode/Lock button until the Scan icon, Memory icon and the memory location number flash on the display.
on the channel/privacy code on which you last received a transmission. This will then return the radio to Standby mode.
If you do not press any button within 10 seconds, your radio will automatically resume scanning privacy codes.
During privacy code scan (while not receiving a transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on the channel/privacy code that was displayed before you entered mode functions or the channel/privacy code on which, during scanning, you last received a transmission. This will return the radio to Standby mode.
b. Press the Mode/Lock button to proceed to set memory location scan (see page 17 for further details).
c. Press the Enter/Hi•Low button to return to Standby
Scanning Locations
Channel Buttons
2.Press the Channel Up or Channel Down button to begin scanning memory locations.
The Scan icon and the Memory icon will continue to be displayed when memory location scan is on. Your radio will continue to scan memory locations and stop if an incoming transmission is detected. Your radio will remain on that memory location for 10 seconds.
While setting memory location scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.
mode on the channel/privacy code that was displayed before you entered mode functions or the channel/ privacy code on which, during scanning, you last received a transmission.
During memory location scan (while receiving an Incoming transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that memory location. Your radio will remain on that memory location and after 10 seconds of no activity, radio will start memory location scan again.
b. Press the Channel Up or Channel Down button to resume scanning memory locations.
|
|
|
|
16 English | Nothing Comes Close to a Cobra® 17 | ||