Cobra Electronics MT 750 manual Operation

Power Saver

OPERATION English

Product Information

This microTALK® radio has been manufactured to meet all required standards for radio equipment using PMR 446 frequencies as authorized. The use of this two-way radio product involves the public airways and its use may be subject to local laws or regulations. Contact your radio licensing authority for more information.

Caring for Your Radio

Your microTALK® radio will give you years of trouble-free service if cared for properly. Here are a few suggestions:

•Handle the radio gently.

•Keep it away from dust.

•Never put the radio in water or in a damp place.

•Avoid exposure to extreme temperatures.

Desktop Charger and

Rechargeable Batteries

Each port can charge one radio. Uses 230 volt adaptor. Use only Cobra NiMH batteries, model GA-3ANH with charger model PA-CD3.

Cobra recommends your radio is turned Off while being charged.

Radio Power

To Turn Your Radio On: Power Button

–Press and hold the POWER button until you hear a series of audible tones indicating that the radio is On.

Your microTALK® radio is now in LISTENING MODE, ready to receive transmissions. The radio is always in LISTENING MODE, except when the TALK, CALL or MODE buttons are pressed.

To Turn Your Radio Off:

– Press and hold the POWER button.

Battery Low Indicator

To Insert Batteries in Radio:

1.Remove belt clip by releasing belt clip latch and sliding clip up.

2.Pull down on lock tab to remove battery cover (on back of radio).

3.Insert GA-3ANH batteries according to polarity markings.

Remove Belt Clip

Lock Tab

Insert Batteries

When battery power is low,	Battery Low
the BATTERY LOW indicator
will blink, indicating that
batteries should be recharged
or replaced.

WARNING: Only the supplied NiMH batteries can be recharged.

Battery/Power Saver

If there are no transmissions

NOTE: Estimated operation time on full charge: 12 hours.

These rechargeable batteries

must be recycled or disposed of properly in compliance with all applicable laws. They must not be thrown in the rubbish bin. Some countries and local authorities require recycling and have established collection programs. Please contact your local waste disposal authority for instructions.

WARNING: Do not put batteries into fire or expose to high heat. They may explode.

For Charging Cobra’s microTALK® Radio(s):

1. Insert radio(s) into the	Insert Radio(s)
charger as shown.

2. Insert round connector of

230 volt adaptor into jack on back of charger.

3.Plug 230 volt adaptor into mains socket.

If charging light is not On, check position of radio. Radio should be upright.

The charge indicator light will stay On as long as the radio is in the charging well, even after the batteries are fully charged.

It normally takes about 15 hours to fully recharge batteries. Batteries will not be damaged if they stay in the charging well longer than that.

within ten (10) seconds, the unit will automatically switch to Battery Save Mode and POWER SAVER will appear in

the display. This will not affect the unit’s ability to receive incoming transmissions.

Communicating with

Another Person

To Talk To Another Person:
1. Press and hold the TALK
	Talk Button
button.

2.With the microphone about 5 cm (2 inches) from your mouth, speak in a normal

voice.	5 cm (2 Inches)
	From Mouth

3.Release the button when you have finished talking and listen for a response.

You cannot receive incoming

calls while pressing the TALK button.

NOTE: Both radios must be tuned to the same channel and privacy code to communicate.