Channel Scan

Mode Functions

Operation

Mode/Lock Button To de-program a memory location:

1.Press the Mode/Lock button until the

Memory icon and the memory location flash on the display.


Introduction	Operation	Customer Assistance	Warranty

•

Your microTALK radio can automatically scan channels.

Mode/Lock Button To scan channels:

1. Press the Mode/Lock button until the

2. Press the Channel Up or Channel Down

button to select the memory location

(0 through 9).

Scan icon and the channel numbers flash on the display.

If a location has been programmed before, its associated channel/privacy code will be shown on the display.

3.	Press the Enter/Hi•Low button. The channel
	numbers will flash on the display.
4.	Press the Channel Up or Channel Down
	button to select Channel 0.
5.	Choose one of the following:

Scanning Channels

Channel Buttons

2.Press the Channel Up or Channel Down button to begin scanning channels.

The radio ignores specific privacy codes while scanning channels.

The Scan icon will continue to be displayed when scan is on. Your radio will continue to scan all channels and stop if an incoming transmission is detected. Your radio will remain on that channel for 10 seconds.

Channel Buttons

Enter/Hi-Low Button

Channel 0

a. Press the Enter/Hi•Low button to enter

the channel/privacy code in the selected

memory location and return to the

beginning of memory location options.

b. Press the Mode/Lock button to

enter the channel/privacy code in

the selected memory location and

proceed to other functions on the

channel/privacy code displayed

before you entered mode functions.

While setting channel scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel or channel/privacy code displayed before you entered mode functions.

During channel scan (while receiving an incoming transmission), you can choose from the following:

a. Press and hold the Talk button to communicate on that channel. Your radio will remain on that channel and return

While de-programming a memory location,

if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.

to Standby mode.

b. Press the Channel Up or Channel Down button to resume scanning channels.

If you press the Talk button while scanning, but more than 10 seconds after receiving a transmission, you will transmit on the channel on which you last received a transmission. This will return the radio to Standby mode.

If you do not press any button within 10 seconds after receiving a scanned transmission, your radio will automatically resume scanning channels.