Battery Saver Mode, Using Your FR-1428 | Audiovox FR1428, FR-142B

CHANGING SNAP-ON FACE PLATE (CONTINUED)

Pull out the face plate from the body of the transceiver using the groove located at the bottom of the speaker grill.

Insert another face plate into the unit and install the two screws in the upper side of the tray in the battery compartment. Replace the batteries and cover.

BATTERY SAVER MODE

Your FR-1428 has a unique circuit designed to dramatically extend the life of its batteries. After 10 seconds of inactivity, the FR- 1428 will switch to battery saver

mode. While in battery saver mode, the battery saver mode indicator ( ) is present on the display, and the transceiver will remain ready to receive any incoming transmissions while the battery saver mode is active. Pressing any of the buttons will exit the battery saver mode and illuminate the display.

USING YOUR FR-1428

Turning the Transceiver On and Off ( )

Pressing the PWR button (7) for 2 seconds will activate the unit and ( on ) momentarily appears on the display followed by the frequency standby display. The speaker will sound a beep tone to confirm the transceiver’s activation. To turn the unit off, simply press and hold the power button for 2 seconds then release it.

Volume Level

Audio reception volume is controlled by the Up (s) and the Down (t) button. Momentarily pressing either button will increase or decrease the volume level. The display will indicate “LE” followed by “ - 1” (lowest setting to “ - 8” highest setting).

Call Button (8)

When the call button is pressed, the FR-1428 will transmit a 3-second ringing sound to other transceiver’s tuned to the same channel. This feature can be used to signal other parties that voice communication is desired. The call icon ( ) appears on the LED display while the call tone sounds.

-10-