Audiovox WHS200 installation instructions Two Channel Automotive Infrared Stereo Headphone System

INSTALLATION INSTRUCTIONS

WHS200

Two Channel Automotive Infrared

Stereo Headphone System

Parts supplied

1.IR transmitter (1)

2.IR Transmitter harness (1)

3.IR headphones (2)

Fig. 1 TRANSMITTER POSITIONING DIAGRAM TRANSMITTER

TRANSMITTER

REAR

FRONT

POSITION IN MIDDLE OF	POSITION JUST ABOVE THIGH AREA OF SECOND PASSENGER
SEATING AREA	ROW SEATING

Notes:

•For best results, IR transmitter must be installed as shown with the LED’s pointing toward the rear of the vehicle (Fig. 1)

•Audio input can be connected to either a low-level fixed audio output or a variable level audio output (such as a speaker or headphone output). If it is connected to a low-level output, only the volume control on the headphones needs to be adjusted to control volume level. If connected to a variable level output, volume adjustment needs to be done at both the source and at the headphones.

Fig. 2	WIRING DIAGRAM
1. GROUND	CHANNEL A	1. LEFT RCA CHANNEL IN
2. WHITE
3. RED		2. RIGHT RCA CHANNEL IN
4. BLACK		3. DC 12V GND – (NEGATIVE)
5. RED		4. DC 12V IN + (POSITIVE)
1. GROUND	CHANNEL B	1. LEFT RCA CHANNEL IN
2. WHITE		2. RIGHT RCA CHANNEL IN
3. RED

Wire harness with RCA connectors (Fig. 2).

1.Using dual RCA (M/M) cable (not supplied, length determined by installation) connect one end to red and white RCA jacks. Connect the other end to low level signal source.

2.Connect pin 4 (black wire, negative) to ground of vehicle.

3.Connect pin 5 (red wire, +12 volt) to ignition source (source that supplies +12 volts when the ignition is switched on).