PN 720018
IMPORTANT INSTRUCTIONS for FAN-FORCED HEATER USE
Please note: the TH106 comes factory set in baseboard mode. If using the TH106 to control a
To change the setting: The configuration switches are on the back of the thermostat. Change factory setting SW3 to the ‘ON’ position (15 minute cycle length). See page two of your thermostat Owner’s Guide, Section 3, Item CONFIGURATION for more detailed instructions.
Factory | Switch to |
“ON” for | |
Setting | Fan Setting |
SW3 | Cycle | 15 seconds | 15 minutes |
| length | Baseboard | Fan Heater |
|
|
|
|
Instructions are also available on our website at www.cadetco.com