2. On the bottom of the MULTIRANGE charger, press and hold the registration button until
the Link light starts to blink (about 2 seconds). Release the button and wait for the
Link light to turn on and steady (this can take about 90 seconds).
If the Link light doesn't turn on or keeps
blinking, disconnect the charger's AC adapter. Wait about 20 seconds, then try these steps again.
Some important things to remember:
Only register one charger at a time. If more than one charger is in registration mode at the same time, they can interfere with each other.
If you want to use the MULTIRANGE charger with a different base, just register the charger to the new base. The charger automatically erases the link to the old base when it registers to the new one.
Only register chargers to one base at a time. If more than one base is in registration mode at the same time, you can't control which base the charger registers to.
AC Adapter and Battery Information
Use only the supplied AC adapters. Be sure to use the proper adapter for the base and any chargers.
Do not place the power cord where it creates a trip hazard or where it could become chafed and create a fire or electrical hazard.
Do not place the unit in direct sunlight or subject it to high temperatures.
Fully charged, the battery should provide about 10 hours of talk time and about 7 days of standby time. For best results, return the handset to the cradle after each call to keep it fully charged.
When the battery gets too low, the handset shows a low battery alert. If you hear a strange beep during a call, check the display: if you see the low battery alert, finish your conversation as quickly as possible and return the handset to the cradle. If the handset is in standby, none of the keys will operate.
33