TROUBLESHOOTING
TROUBLESHOOTING
The status light won't illuminate | Make sure the AC adaptor is plugged into each base and wall outlet. | ||
when the handset is placed on | Make sure the handset is properly seated in the base. | ||
the base. | Make sure the charging contacts on each handset and base are clean. | ||
|
|
| |
The audio sounds weak and/or | Move the handset and/or base to a different location away from | ||
scratchy. |
| metal objects or appliances and try again. | |
| Press | /channel while on a call to change the operating channel. | |
|
| ||
| Make sure that you are not too far away from the base. | ||
|
| ||
|
|
| |
Can't make or receive calls. | Check both ends of the telephone line cord are plugged in firmly. | ||
| Make sure the AC adaptor is plugged into the base and wall outlet. | ||
|
| ||
| Disconnect the AC adaptor for a few minutes, then reconnect it. | ||
|
| ||
| Make sure that you are not too far from the base. | ||
|
| ||
| Charge the handset. | ||
|
| ||
|
|
| |
The handset doesn't ring or | The battery pack may be weak. Charge the battery for | ||
receive a page. | The handset may be too far way from the base unit. | ||
| Place the base unit away from appliances or metal objects. | ||
|
| ||
|
|
| |
Caller ID does not display. | The handset was picked up before the second ring. | ||
| The call was placed through a switchboard. | ||
|
| ||
| Call your local telephone company to verify your Caller ID service is current. | ||
|
| ||
|
| ||
If you still have a problem. | Australia: www.uniden.com.au New Zealand: www.uniden.co.nz | ||
|
|
|
|
|
| Page 17 |
|