Uniden OCT4960-2 manual I C K R E F

Step 1 Charging the Battery

INSTALL THE HANDSET BATTERY

Remove the cover.

Connect the battery pack connector with the correct polarity.

Replace the cover.

Step 2 Connecting/Adjusting

CONNECT TO A PHONE LINE

When the handset battery pack is fully charged, plug the telephone cord into the base unit then into a telephone wall jack.

Your phone is set for tone dialing. If your local network requires pulse dialing, please see page 10 “Choose the dialing mode” in your owner’s manual.

Step 3 Using the Phone

TO MAKE A CALL

hone	caller
book	id
end

talk

		flash
1	2 abc	3def
4 ghi	5 jkl	6mno
7pqrs	8 tuv	9wxyz
tone	0oper

Press talk and listen for dial tone.

Dial the desired number.

Q U I C K R E F

PLUG INTO AC POWER

ADJUST HANDSET RINGER VOLUME		Press end or return the handset to the
AND RINGER TONE		base to hang up.
	12-15 hours before using the phone.

E R

Plug the AC adapter cord into the base unit and charger to a standard 120V AC outlet.

Place the handset on the base and the charger.

Note: You must charge the battery pack for 12-15 hours before using the phone.

Press menu/enter and press ▲ or ▼ to select “Line Ring”, “Ringer Volume” or “Ringer Tone”.

Press menu/enter.

Press ▲ or ▼ to change the setting.

Press menu/enter to confirm your selection.

phone	caller
book	id
end

talk

		flash
1	2 abc	3def
4 ghi	5 jkl	6mno
7pqrs	8 tuv	9wxyz
tone	0oper

TO ANSWER A CALL

Press any number key on the handset or lift the handset (AutoTalk) from the base.

Adjust the handset volume louder or softer by pressing

▲or ▼ during a call.

phone	caller
book	id
end

talk

		flash
1	2 abc	3def
4 ghi	5 jkl	6mno
7pqrs	8 tuv	9wxyz
tone	0oper

hold menu redial int’com

format enter pause delete

E N C E G U I D

hold menu redial int’com

format enter pause delete

E