Motorola T5200 manual Troubleshooting, Noise on a, To communicate with T5100 radios Channel

Page 14

Troubleshooting

Problem	Solution

No Power	Reposition or replace batteries.

Erratic Display	Reposition or replace batteries.

Message Not	Make sure the Push-To-Talkbutton is completely pressed as you transmit.
Transmitted	Reposition or replace batteries.
	Reposition or replace batteries.
	Shared Channel may be in use, try another.

Message Not Received

Confirm radios have same Channel settings and/or Interference Eliminator Code is inactive (non T5100 radios).

Make sure Push-To-Talkis not inadvertently being pressed. Reposition or replace batteries.

Obstructions, operating indoors or in vehicles may interfere with communication. Change your location.

Check to make sure volume is turned up.

	HearingOther	Shared Channel may be in use, try changing channels.
	Conversation or	Radios with Interference Eliminator Codes (like T5200), must have codes off or set to zero
	Noise on a
	Noise on a	to communicate with T5100 radios.	15
	Channel	to communicate with T5100 radios.	15
	Channel

Image 14

Contents Your New Radio T5200 OnlyRadio Etiquette To InstallBatteries Front Cover Reinsert housing tab Press down to snap cover into placeBelt Clip To AttachTo Communicate Channel Busy IndicatorAdjust The Volume Turn The Radio OnSet The Channel Time-out TimerMenu/Lock Button Set The Code T5200 onlyRoger Beep Call ToneSet The Call Tone T5200 only Sending MessagesLow Battery Alert AccessoriesBattery Meter To Use Audio AccessoriesTalk Range Care of Your RadioExposure to Radio Frequency Energy Safety and General InformationRF Operational Characteristics Antenna Care Approved AccessoriesPortable Radio Operation and EME Exposure Two-way Radio OperationAircraft Electromagnetic Interference/CompatibilityFacilities Medical DevicesSafety and General Use While Driving Operational WarningsOperational Cautions AntennasTo communicate with T5100 radios Channel TroubleshootingNoise on a Limited Talk Location of radioMotorola Limited Warranty II. Other Warranty ConditionsGeneral Provisions VII. State and Jurisdiction Law Rights FCC License Not Required Channel Frequency Chart Interference Eliminator Code Chart Specifications Description T5100 Specs T5200 SpecsPage Table of Contents ¥ Keypad Lock ¥ Up to 2 mile range