Troubleshooting Guide

2.Plug the AC adaptor plug into DC power Jack at the rear side of base.

3.Press the power button on the base or remote control to turn the unit on. Switch on the speakers to play your iPod. Choose the best channel through the “Channel” button at the rear of the base until the speakers receive the right signal.

4.Press ‘Vol+” or ‘Vol-‘ to choose a proper volume level, then you should now be able to take the speakers freely from room to room without disruption (Subject to its surroundings, approximately 100 feet in the open area without any interference).

5.If using iPod shuffle or other audio source with 3.5 mm headphone output jack, connect it to the AUX line in jack on the rear of base. (AUX in will not work when an iPod is docked)

6.Press the power button on the base or remote control to turn off the unit.

Should you experience difficulties in the use of this player, please refer to the following chart or call 1-800-777-5331 for Customer Service.

Symptom	Possible problem	Solution
The base does not	AC adaptor is not plugged into a	Plug the AC adaptor into a wall outlet
switch on (no power)	wall outlet or the connector is not	and plug the connector into the DC
	plugged into the DC jack on the	jack on the unit.
	back of the unit.

	Wall outlet is not functioning.	Plug another device into the same
		outlet to confirm the outlet is working.
	Using no/wrong iPod cradle.	Make sure the dock cradle is the
		proper fit for your iPod.
iPod does not	iPod is not installed properly.	Remove your iPod from the dock and
respond to the		check for any obstruction on the
speaker system		connectors in the docking and on
		your iPod. Then reseat it in the dock.

	Your iPod is locked up.	Please make sure that your iPod is

TROUBLESHOOTING GUIDE

switch on (no power)

speaker system