Jensen JiSS-100 owner manual Radio Operation, To Preset Channels

Page 7

RADIO OPERATION

1.Press the Button to turn on the unit.

2.Press the FUNCTION Button to operate the unit in AM or FM mode.

 

 

780AM

 

92 6FM

 

 

 

 

 

 

 

 

 

TO:

PRESS:

 

 

 

Scan radio station automatically

TUN UP/

or TUN DN/

Buttons and hold for 1 second

Stop auto-tuning

TUN UP/

or TUN DN/

Buttons again

Scan radio station manually

TUN UP/

or TUN DN/

Buttons repeatedly

Adjust the volume level (0~16)

VOLUME

or VOLUME

Buttons

Select the EQ

EQ Button repeatedly until the desired EQ shown in the Display

3. To turn JiSS-100 off, press the Button again.

Note:

i.When listening to an FM station, fully extend the telescopic antenna and adjust the angle to insure maximum reception.

ii.Automatic tuning operation may vary depending on the broadcast signal strength and also your distance from the broadcast tower, so weaker stations may be skipped. Tune manually to find the weaker stations. With stronger stations, the tuner may stop before it reaches the optimum setting for that station. Adjust tuning manually for the best reception if necessary.

iii.If FM reception is weak, try repositioning the unit near an open window or rotating the antenna until you get the best reception.

iv.For best AM reception, please undock your iPod when listening to AM stations.

v.The sound equalization can be adjusted for optimum sound reproduction depending on the style of music you are playing. By pressing the EQ Button, you can switch between ROCK, POP, JAZZ, CLASSIC, or FLAT equalization to suit your taste.

Flat RockPOP JAZZCLASSIC

To Preset Channels

The JiSS-100 is equipped with 20 preset memories each for the AM and FM band.

1.Press the Button to turn on the unit.

2.Press the FUNCTION Button to operate the unit in AM or FM mode.

3.Tune to a desired station.

4.Press and hold the MEMORY Button until the Channel Indicator “P-01” appears and flashes in the

Display.

ROCK

P-0 1

5.While the Channel Indicator “P-01” is flashing press the TUN UP/ or TUN DN/ Buttons to select the desired preset channel.

6.Press the MEMORY Button again to confirm when the desired preset channel appears in the Display.

7.Tune to another station and repeat steps 4 to 6 to store the new station in another preset channel.

6

Image 7
Contents Portable Docking Music System for iPod Important Safety Instructions Important Safety Instructions Protect Your Furniture FCC NoticeLocation of Controls WelcomeBattery Replacement Power SourceBattery Operation Battery PrecautionsRadio Operation To Preset ChannelsAUX Operation To Receive Preset StationsCare and Maintenance Using Headphones not IncludedTroubleshooting Guide SpecificationsDAY Limited Warranty and Service