Installation
ENGLISH
Removing the unit
1.Frame
2.Insert fingers into the groove in the front of frame and pull out to remove the frame. (When
3.Lever
Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard.
- DIN Rear-mount (Method B)
Installation using the screw holes on the sides of the unit.
Fastening the unit to the factory radio mounting bracket.
1.Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned, and tighten the screws at
2 places on each side. Uses truss head machine screws (M4⋅6), depending on the shape of the screw holes in the bracket.
2.Truss head machine screw (M4⋅6)
3.Factory radio mounting bracket
4.Dashboard or console
5.Hook (Remove this part)
•Note:
The mounting box, outer trim ring, and
7