Sequential Play

Basic Play

Track number in play

VOL

C S-XBSTRAIN

ALL1 M

RANDOM

SORRY

Elapsed playing time of each track

5	VOL	VOL
		VOL
		C S-XBSTRAIN
	VOL	ALL1 M
	Increase	RANDOM
	Increase	SORRY

Decrease	1 OPEN

Label must face upward.

O		3
P
R
O	F
	F

Follow steps 1–5.

HOLD

Plug type:	2
3.5 mm (1/8 in.) stereo	2	Close the lid
	R	L

Resume function

In step 2: Connect the stereo headphones and wired remote control to the headphone jack [Ë]. (Plug in ﬁrmly.)

In step 5: The volume range is 0-25. Press and hold to change the volume successively. The volume changes when pressed while the level is displayed. If any other display is shown, it changes to show the current level. (The volume returns to 10 when you disconnect the power source.)

≥Play stops automatically when all the tracks have been played.

≥If the unit has been connected to the car audio system, set this unit’s volume to 10, then adjust the volume level on the system.

The player stores the track where you stopped play and if you press [1;] (main unit) or [∫/1] (remote control), play resumes from the beginning of the track.

The resume function is canceled (play starts from the ﬁrst track) if you open the lid when the unit is stop mode. It is also usually canceled when you replace the CD while the unit is off.

Operation

To pause play

To stop play

Stop mode

To turn off the

unit Off mode

Skip forward/

backward

(skip function)

Rapid forward/

backward

(search function)

Button

Press during play.

O
P
R
O
F
	F
Press during stop mode.
O
P
R
O
F
	F

Press during play.

(Press [:] twice to skip to the beginning of the previous tracks.)

Backward

Forward

Press and hold during play.

Display/reference

Press again to restart play.

VOL

C S-XBSTRAIN

ALL1 M

Total number of tracks

VOL

C S-XBSTRAIN

ALL1 M

Total playing time

VOL

C S-XBSTRAIN

ALL1 M

≥During program play (page 4), these buttons are used to skip forward or backward through the programmed sequence of tracks.

≥You cannot skip to tracks that have been played in random or random repeat play (page 4).

≥During program play, 1-track repeat play, random play and random repeat play (page 4), search op- eration is limited to the current track only.

Note!

≥The resume function may work if you replace the CD while the unit is off.

≥If you turned the unit off near the end of the track, play may resume from the beginning of the next track.

≥The resume function works automatically and cannot be turned off.

Removing discs

1Press [∫,OPR OFF] to stop play and disc rotation.

2Slide [OPEN 1] to open the lid.

3Press [PUSH] to release the disc.

Do not stop the disc by hand or try to remove it before it stops rotating. This can damage CDs.

HSUP

PUSH

Note!

Never insert foreign objects into the unit.

Auto power off function

If the unit is left in stop mode for approximately 10 min- utes, the unit powers itself off automatically in order to

For your reference:

“ ” indication

This indication appears for about 30 seconds if [1;] (main unit) or [∫/1] (remote control) is pressed when no disc is loaded in the unit or if the disc is not properly secured.

“*” indication

This indication appears for about 10 minutes when the lid is opened. (However, the indication does not appear when the unit is powered off.)

prevent the battery from running down.

(If no disc is loaded in the unit, it powers itself off in about 30 seconds.)

Note on CD-R and CD-RW

This unit can play CD-DA format audio CD-R and CD-RW that have been ﬁnalized§ upon completion of recording. It may not be able to play some CD-R or CD-RW due to the condition of the recording.

§Finalizing is a process that enables CD-R/CD-RW players to play audio CD-R and CD-RW.